1. DL manuals
  2. Lacanche
  3. Ventilation Hood
  4. L2HM 1000
  5. Installer manual

Lacanche L2HM 1000 Installer manual

Manual is about: KITCHEN RANGE HOODS

Summary of L2HM 1000

  • Page 1

    L2hm 900 - l2hm 1000 - l2hm 1100 - l2hm 1200 l2hm 1300 - l2hm 1500 - l2hm 1600 - l2hm 1700 l2hm 1700 - l2hm 1800 - l2hm 2000 - l2hm 2100 - l2hm 2200 - l2hm 2400 lacanche kitchen range hoods hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 1/28.

  • Page 2

    Technical data sheets, measurements and dimensions —————————————————————————————————————————3 installer’s manual 7 sitting —————————————————————————————————————————9 setting up the hood —————————————————————————————————————————13 setting up of groups —————————————————————————————————————————17 insta...

  • Page 3

    Installer’s manual a b l2hm 900 900 385 l2hm 1000 1000 485 l2hm 1100 1100 585 l2hm 1200 1200 685 l2hm 1300 1300 785 l2hm 1500 1500 985 l2hm 1600 1600 1085 l2hm 1700 1700 1185 l2hm 1800 1800 1285 l2hm 2000 2000 1485 l2hm 2200 2200 1685 l2hm 2400 2400 1885 technical data sheets, measurements and dimen...

  • Page 4

    Installer’s manual lacanche kitchen range hoods - decorative single and double blower unit kitchen range hoods in canopy widths from 900 to 2 000 mm. Caution : under no circumstances shall the distance between the exhaust hood and the wall or ceiling exhaust opening exceed 9 metres. Make sure that t...

  • Page 5

    Installer’s manual technical data sheets, measurements and dimensions directives : low voltage : 2006/95/cee cem : 2004/108/cee connecting exhaust duct : attention: cut exhaust duct(s) and make sure duct, when run through the hole in the base of the installed hood protrudes far enough to be connecte...

  • Page 7: Installer’S Manual

    L2hm 900 - l2hm 1000 - l2hm 1100 - l2hm 1200 l2hm 1300 - l2hm 1500 - l2hm 1600 - l2hm 1700 l2hm 1700 - l2hm 1800 - l2hm 2000 - l2hm 2100 - l2hm 2200 - l2hm 2400 installer’s manual appliances must be installed in a workmanlike manner in accordance with the instructions in this manual and locally appl...

  • Page 9: Sitting

    Installer’s manual sitting cautions : the purchaser undertakes to install or arrange for his/her equipment to be installed in a workmanlike manner and in accordance with the applicable regulations and standards. Shipment-packaging : carton packing crate on wooden palette unpack and check the applian...

  • Page 10: Sitting

    Installer’s manual sitting lacanche range hoods install horizontally at a minimum distance of : - 65 cm over electrical range. - 80 cm over gas range. Make sure hood is installed perfectly horizontal and cannot dip forward. Use aluminum duct and choose shortest and straightest pathway. Do not connec...

  • Page 11: Installation

    Installer’s manual preparing the extractor hood : 1 2 - loosen the screws holding the front of the hood (item a 2 ) 3crew- 1 a a a a 2 installation hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 11/28.

  • Page 12: Installation

    Installer’s manual installation 3 - stand the extractor hood upright. 3 . 3 hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 12/28.

  • Page 13: Setting Up The Hood

    Installer’s manual a length of the hood - 420 mm 2356 1799 !Xisofthehood to position if back panel installing hood : 4 . 2 - positioning and securing the two brackets to hood (screw-type m5). Setting up the hood 4 hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 13/28.

  • Page 14: Setting Up The Hood

    Installer’s manual setting up the hood 2356 1820 axis of the hood attach the trim back the hood before note: if a back cover is used, install the back cover before mounting the hood. 5 5 hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 14/28.

  • Page 15: Setting Up The Hood

    Installer’s manual 6 and 7 . 6 - to level by tightening or loosening the 2 screws 6532570 and 6535377. 7 - end of the hood to the wall plate by tightening the screws 6535377. 6532570 6535377 setting up the hood 6 hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 15/28.

  • Page 16: Setting Up The Hood

    Installer’s manual mandatoryattachments setting up the hood 7 hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 16/28.

  • Page 17: Setting Up Of Groups

    Installer’s manual setting up of groups 8 and 9 : remove glass center intake panel . Loosen black side cover screws . Loosen 8 screws . Push blower unit(s) into cutout until they bottom with rotary switch facing forward and to the right. Make sure locking lugs hold blower unit(s) securely in place. ...

  • Page 18: Setting Up Of Groups

    Installer’s manual setting up of groups setting up in the hood 10 remove the 4 screws on media panels and drop media panels media panel prepare the extractor unit and use the locking brackets to position it/ item b 11 and 12 (see «assembling the unit(s)» section) 10 11 12 b hottes - ft 118a - gb - r...

  • Page 19: Setting Up Of Groups

    Installer’s manual setting up of groups fasten the extractor unit(s) to the hood by tightening the 4 screws on either side of the 13 (see «assembling the unit(s)» section). 14 15 . 13 14 15 hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 19/28.

  • Page 20

    Installer’s manual installing the extractor hood extension see rating of 250 from your ceiling and adjust the media hides sheath in boutonnièress provided for this 16 . 17 ). 16 17 hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 20/28.

  • Page 21

    Installer’s manual 18 . Caution : do not force the jacks when tightening. Replace the media cover and secure. Replace the front facing of the extractor hood by performing the above operations in reverse order. Media façade front panel caches beams right and left cache front beam installing the extra...

  • Page 22

    Installer’s manual hold cover in place and fasten back of cover using a stainless steel m5 screw. And . Installing mounting channel covers hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 22/28.

  • Page 23: "hottes"

    "hottes" user’s manual important in accordance with the applicable regulations and standards in an adequately ventilated room. Installer. Any changeover to a voltage other than that for which the appliance is set up must be carried out by a warranty the warranty is stated on the sales contract. Plea...

  • Page 24: User’S Manual

    User’s manual use —————————————————————————————————————25 cleaning and maintenance —————————————————————————————————————26 note concerning the disposal of waste electrical and electronic equipment —————————————————————————————————————28 this range has the marking, i.E. It meets the essential require...

  • Page 25: Use

    User’s manual use operating principle : lacanche range hoods are available with a single (lhm 900) or two 600 m 3 /h blower units (other for normal operation : - place pans on range so hood catches all vapor and smoke. - avoid cross-drafts. - match fresh air intake to exhaust volume to avoid loss of...

  • Page 26: Cleaning And Maintenance

    User’s manual unclip bottom a b . Stainless steel casing : use special stainless steel cleaners (zip inox®, johnson inox®, ppz inox®, for instance). Do not use abrasive cleaners. Epoxy-coated casing : sponge with soapy solution. Before any cleaning operation check that the appliance is disconnected ...

  • Page 27: Cleaning And Maintenance

    User’s manual fluorescent tube replacement pull to unclip diffuser and replace tube. Push diffuser back in place. 1600), pl 11 w tubes for range hood models l2hm 900, l2hm 1700 to 2200. Cleaning and maintenance hottes - ft 118a - gb - rév 08 - modifié le : 06/07/2015 27/28.

  • Page 28

    Instruction manual decree no. 2005-829 of 20 july 2005 transposing european directives 2002/95/ec and 2002/96/ ec on hazardous substances in electrical and electronic equipment and on the disposal waste electrical and electronic equipment. Electrical and electronic equipment (eee) and waste electric...