Page 1 of 17 – us – f ourneau « rully » installation manual appliances must be installed in a workmanlike manner in accordance with the instructions in this manual and locally applicable regulations. This manual will be handed over to the user after installation..
Page 2 of 17 – us –.
Page 3 of 17 – us – cabinet preparation : all depth measurements below are with a 50mm (2”) range spacer installed: range height a (min*) b c d e (max) f g (max) h i j default 900mm 35 3/8’’ 457mm 18’’ 914mm 36’’ 330mm 13 ’’ 50mm 2’’ 700mm 27 9/16’’ 638mm 25 1/8’’ 130mm 5 1/8’’ 215mm 8 7/16’’ 705mm ...
Page 4 of 17 – us – before connection : check: - pipework is perfectly clean in order to prevent the injectors becoming blocked and malfunctioning of the magnetic heads. - the gas for which the appliance was set up: rating plate and markings. - cross-sectional area of gas supply pipework is compatib...
Page 5 of 17 – us – remove the pan supports and burners. Unscrew the screw(s) c on burner uf or t (figures 4 & 5). Pull and raise the top after having loosened the 2 screws d (fig. 6), then prop the cooking surface. A pressure regulator (fig. 7) is located in the right rear corner under the hob, to ...
Page 6 of 17 – us – in case of use with a gas other than that for which the appliance was initially set up, it is crucial to replace the orifices and modify the adjustments as defined below. Top burners: orifice: lift the air ring e. Replace the injectors f in accordance with table 3 and figure 10 (...
Page 7 of 17 – us – adjustment of reduced flowrate of surface burners (figure 23): after connection or change of gas, it is crucial to modify this adjustment. - remove the control knob. Light the burner, adjust to minimum setting, then use a small screwdriver to set the adjusting screw j. Note: flam...
Page 8 of 17 – us – oven orifice: to replace oven orifice: remove oven baseplate. Caution: when refitting place the base underneath the groove on the fascia (figures 16 and 17). Remove screws l (figure 18). Remove the screen below the oven (figure 19). Loosen screw m then slide open the burner air ...
Page 9 of 17 – us – fig. 23 p electrical it is hazardous to put the appliance into service without connecting it to suitable ground. No liability can be accepted for accidents resulting from non-compliance with this requirement or incorrect grounding. before connection, check that the: mains volta...
Page 10 of 17 – us – back spacer vent fitting: it is mandatory to mount the back spacer vent r to the range supplied with the appliance. Screw the wall spacer to the range according to figure, 26, with the thumbscrews and hardware provided. Then move the range backwards into position. This spacer is...
Page 11 of 17 – us – stability device installation instructions: anti-tip bracket is designed to fit into the seam formed at the bottom of the range chassis and base plinth as shown in figure 1.The bracket can be mounted anywhere along the seam that the bracket can be freely inserted (figure 2). Mou...
Page 12 of 17 – us – service instructions: - lubricating gas valves. If the gas taps tends to stick slightly, you may follow this procedure: 1 - shut off the gas supply valve and / or the main electrical supply of the unit. 2 - take out the knob corresponding to the gas valve to be greased. 3 ...
Page 13 of 17 – us – gas circuit diagramme designation part number burner cap 1,5 kw 65.330004 burner cap 3,0 w 65.330005 burner cap 4,0 kw 65.330006 burner cap 5,0 kw 65.330007 burner bowl 1,5 kw 65.640008 burner bowl 3,0 kw 65.640004 burner bowl 4,0 kw 65.640005 burner bowl 5,0 kw 65.640006 air sh...
Page 14 of 17 – us – 65.39895 65.226006 65.080005 65.033018 1,5 kw = 65.064007 3,0 kw = 65.064007 4,0 kw = 65.064007 5,0 kw = 65.064007 65.103029 + 4 screws 65.129101 + 4 disc 65.30932 65.103033.
Page 15 of 17 – us – détail a: détail b: 65.103032 (lp) 65.103031 (ng) 65.103029 65.103033 65.103033.
Page 16 of 17 – us – item n° designation b top burner electrode 65.226006 s1 switch 65.103030 120 v 60 hz n l1 gr s ht n 4 l 5 ht n 4 l 5 gr s ht n 4 l 5 ht n 4 l 5 gr top burners (code a,e,5,n,d,t,i,c,01,02,03,0o,0t) / gas grill (code 0y) ht n 4 l 5 ht n 4 l 5 gr s1 b b.
Page 17 of 17 – us – item n° designation tl three pole limiting thermostat 65.39942 th oven regulating thermostat 65.224010 km contactor 65.223001 s2 thermostat switch 65.52194 i inverter 65.222012 r roof heating element 65.211030 r1 base heating element 65.211026 r2 circular heating element 2650 w ...
