LaCie eSATA PCI Card User Manual - page 8
LaCie eSATA PCI Card •
DESIGN BY SISMO
Installing Your LaCie PCI Card
User Manual
page 8
3.2. Jumper Shunt Adjustment
3.2.1. Mac Users
Before physically installing your PCI card, you must switch the
jumper shunt or your PCI card will not work.
With the ports pointing up, detach the jumper shunt from the top
two jumper pins (1 in the diagram at right) and re-attached the
jumper shunt to the bottom two jumper pins (2 in the diagram
at right).
3.2.2. Windows Users
IMPORTANT INFO:
Adjusting the jumper shunt will disable
the card’s hardware RAID function.
Do not adjust the jumper shunt unless you intend to connect a
LaCie d2 Quadra v3 hard drive to the card.
If the jumper shunt
is not adjusted, connecting a LaCie d2 Quadra v3 hard drive to
the card will not work.
If connecting this drive is your intention, follow the steps below.
Remember that this process will remove the card’s support for
hardware RAID.
1. Adjust the jumper shunt as described in section
3.2.1. Mac
Users
(and refer to the illustrations at right).
2. You must also install the non-RAID drivers for Windows XP/
Vista/7. These drivers are not available on the CD-ROM that
came with your eSATA PCI card; you must download them
from:
http://www.lacie.com/support/drivers/driver.htm?id=10238