Lacrosse WS-9037U-IT Quick Setup Manual - page 5
Model: WS-9037U-IT www.lacrossetechnology.com/support Page | 5
• Once connected, the icon will show for 3 seconds when outdoor
temperature update is received.
• The channel indicator will show below the reception icon.
• Press the SNOOZE/CH button to view sensors on other
channels.
Note: Channel 1 will not show if only one sensor is
connected.
Setup with Multiple Sensors
1. Insert batteries into sensor 1
2. Insert batteries into the forecast station
3. When outdoor temperature appears, insert batteries into sensor 2
4. When channel 2 appears insert batteries into sensor 3
5. Keep the forecast station and all sensors together for 15 minutes.
24 Hour Pressure History Graph
• The bar chart indicates the air pressure history
trend over the last 24 hours.
• The columns represent the pressure change
(”InHg” or “hPa”) readings at specific times.
•
The “0” is equal to the current pressure and
each bar represents how past pressure was
compared to the current pressure.
• Read the graph from left to right. If the bars are rising, it means that
the weather is getting better due to the increase of air pressure.
• If the bars go down, it means the air pressure has dropped and the
weather is expected to get worse from the present time.
• The numeric barometric air pressure reading is displayed directly
under the weather forecast icon. You can set this to your local
reporting station through the program menu
.
Manual WWVB Atomic Time Signal Search
For information about WWVB visit:
www.nist.gov/pml/div688/grp40/wwvb.cfm
ATOMIC SIGNAL SEARCH:
The forecast station will search for 1 hour between midnight and 6am
until the WWVB time signal is received. After reception, the forecast
station will only search for the atomic signal after midnight.
Low Battery Icon
• The low battery icon will show when the forecast station
needs fresh batteries.
Outdoor
Channel
Icon
2
WWVB
ATOMIC
ICON
Low Battery
Icon