Ladan 18 Instruction For Use, Installation And Assembly

Manual is about: Wood gasification boiler

Summary of 18

  • Page 1

    1 ladan wood gasification boiler instruction for use, installation and assembly of boiler..

  • Page 2

    2 general description: we are introducing you the ecological wood gasification boiler of the output 18, 25, 40, 60, 80kw. The hot-water boiler is designed for heating of apartment, family house, guest house, smaller industrial workshop and similar object . The boiler is designed for burning of wood ...

  • Page 3: Technical Parameters:

    3 technical parameters: type of boiler ladan 18 25 40 60 80 boiler output kw 18 25 40 60 80 feed hopper capacity dm3 75 113 180 250 360 door dimension /h-w/ mm 270x450 270x450 270x450 370x570, 270x570 370x570, 270x570 prescribed chimney draught pa 10 23 23 28 32 test overpreassure bar 4 4 4 4 4 max....

  • Page 4

    4 protection of boiler against overheating. Attention: according to the en 303-5 standard the safety cooling circuit against the boiler overheating must not be used for other purposes than to protect boiler against overheating..

  • Page 5

    5 1. Drain valve danfoss - bvts, ¾“ 2. Submersible case with temperature-sensitive element 3. Safety cooling heat exchanger 4. Drain to sump 5. Boiler 6. Inlet of cold water valve danfoss – bvts is on the outlet of the cooling circuit of which sensor is placed at the side part of a boiler and protec...

  • Page 6: Dimension Scheme:

    6 dimension scheme: boiler sketch.

  • Page 7

    7.

  • Page 8: Boiler Operation:

    8 boiler operation: before making fire it is necessary: - familiarize with the attendance of electronic boiler regulation - check water pressure in the central heating system - check if the boiler is connected to the mains making fire in the boiler - set the heating temperature - select the fan spee...

  • Page 9: Door Tightness:

    9 after removing a fan and air inlet cover we can see the two tubes that lead air into the nozzle and to two holes at the upper door. These holes should be cleaned with a small brush and vacuum cleaner. Turn on the fan and check by hand the clearness of air. Put the cover of air inlet and fan back. ...

  • Page 10: Problems Solution

    10 problems solution defect cause/remedy boiler has a lower output as it was a new one - clean up air inlet system - clean up blades of fan - use dry wood afterclosing the flue shutter the boiler burns for a while and then smoke - insufficient quantity of primary air - clean up the primary air inlet...

  • Page 11

    11 scheme of boiler ladan 25 kw: 1. Electronic regulation 14. Thermometer 2. Upper door 15. Thermal fuse / emergency thermostat / 3. Pull rod of chimney shutter 16. Water output socket 4. Loading chamber 17. Upper back cover 5. Conduit of primary air 18. Make a fire flap 6. Fan shutter 19. Cover of ...

  • Page 12

    12 picture of thermal sensor and emergency thermostat: 1. Upper metal sheet of the boiler 2. Socket of outlet water 2“ 3. Temperature sensor 4. Emergency thermostat /in case the temperature is higher than 110 °c the fan turns off /.

  • Page 13

    13 scheme of loading chamber: length of chamber is 590-1000 mm loading chamber.

  • Page 14: Assembly Regulations

    14 assembly regulations basic connection scheme of boiler ladan into the central heating system the boiler should be connected into the central heating system of which the capacity is appropriate to the boiler output. The boiler must be connected to the flue by the shortest way. Other appliances mus...

  • Page 15: Installation Instruction

    15 installation instruction place a boiler on the fireproof thermally isolated floor overhung boiler floor plan at least 500mm on the each side. It is necessary to keep at least minimum specified safety distances of external boiler outlines and exhaust pipe from any combustible and medium combustibl...

  • Page 16: Certificate Of Warranty

    16 certificate of warranty . Type of boiler .......................................................................... Ladan production number .................................................................. Checked by : ............................................................................ ...