Summary of dirty dragon
Page 1
Owner’s manual.
Page 2: Table Of Contents
Dirty dragon guitar amplifier owner’s manual page 2 table of contents introduction............................................................................................................................... 3 front panel ...............................................................................
Page 3: Introduction
Dirty dragon guitar amplifier owner’s manual page 3 introduction the old saying, big things come in small packages is captured in amplifier form. Requested by players looking for a simple and portable amplifier with massive tone that won't break your back loading in. Stripped down to the bare essent...
Page 4: Front Panel
Dirty dragon guitar amplifier owner’s manual page 4 front panel 1 - input - ¼” jack that delivers the signal from the guitar to the first stage of gain in the amplifier. 2 - volume - adjust the overall loudness and gain of the amplifier. 3 - bass – adjust the low frequency response of the amplifier....
Page 5
Dirty dragon guitar amplifier owner’s manual page 5 5 – play/standby/off – an all-inclusive function control - go from off to standby to play, with one switch. When powering the amplifier on, the unit should be switched to the standby position for at least five (5) minutes before switching to the pl...
Page 6: Rear Panel
Dirty dragon guitar amplifier owner’s manual page 6 1 2 3 4 rear panel 1 – fuse- this is the line fuse for the amplifier. The proper fuse should be installed as indicated on the rear panel of the unit. The table below shows the proper fuse to be used with the indicated line voltage. Note: failure to...
Page 7: Specifications
Dirty dragon guitar amplifier owner’s manual page 7 specifications output power >16 watts class a/b output impedence 4 minimum load only!! Input 1 m equalization bass, treble - modified baxandall tone stack notice: ladner engineering reserves the right to change, modify or eliminate any and all ...
Page 8: Tube Placement
Dirty dragon guitar amplifier owner’s manual page 8 back front tube placement v1: input stage (mullard 12ax7a) v2: tone (sovtek 12ax7lps) v3-v4: output (tung sol 6v6) caution : tubes are hot when in use, and for a while after the unit has been turned off, use extreme caution when changing..
Page 9: Warranty
Dirty dragon guitar amplifier owner’s manual page 9 warranty all ladner amplifiers sold by authorized ladner dealers are warranted by ladner engineering group to be free from defects in material or workmanship under normal use and service for a period of five (5) years* on parts and three (3) years*...
Page 10: Replacing Tubes
Dirty dragon guitar amplifier owner’s manual page 10 always turn power off when changing or replacing tubes safety information do not expose this amplifier to moisture or water (i.E. Avoid dropping into swimming pools, most lakes, water ways or use during times of excessive storm surge)** or extre...
Page 11
Dirty dragon guitar amplifier owner’s manual page 11 thank you for your purchase, and welcome to the ladner engineering family. We wish you many years of great tonal bliss with your hand-built dirty dragon. Andrew and d.C ladner.