Ladner G-1 Owner's Manual - Note:
Model G-1 Guitar Amplifier Owner’s Manual
Page 8 of 14
produces more high-end sparkle. The Presence
control is very functional and powerful to the
overall tone and has more range than most
conventional amplifiers.
4 - FOOTSWITCH – Connection for the channel
selection footswitch, a standard TRS or Tip Ring
Sleeve cable is required.
NOTE:
The front panel
selector switch is disabled when the footswitch
is plugged into this jack.
A faulty footswitch or
flaky cable can cause the amp to default to the
OverDrive Channel!!!
FOOTSWITCH CONNECTION DETAILS
5 – SLAVE LEVEL - A tap off the output to send
an unbalanced signal to a power amplifier or
recording console. The slave level controls how
much signal is sent to the Slave Output jack.
The slave level can deliver signals above line
level.
NOTE: A proper load must be connected
to the amplifier (i.e. Speaker cab or load box)
or you will (possibly, pretty good chance) blow
the amp up … which is no fun.