Lagan DW60 User Manual - page 15
If not possible, empty the appliance and close
the door. Disconnect the water inlet hose and
remove water from the water inlet hose.
What to do if…
The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution
to the problem yourself, contact your dealer or the After Sales Service.
Problem
Possible cause
Solution
• Continuous flash
of the start/can-
cel indicator light.
• 1 flash of the end
indicator light.
Malfunction:
The dishwasher
does not fill with wa-
ter.
The water tap is blocked or furred
with limescale.
Clean the water tap.
The water tap is closed.
Open the water tap.
The filter in the water inlet hose is
blocked.
Clean the filter.
The connection of the water inlet
hose is not correct. The hose can be
kinked or squashed.
Make sure that the connection is
correct.
• Continuous flash
of the start/can-
cel indicator light.
• 2 flashes of the
end indicator
light.
Malfunction:
The dishwasher will
not drain.
There is a blockage in the sink spi-
got.
Clean the sink spigot.
The connection of the water drain
hose is not correct. The hose can be
kinked or squashed.
Make sure that the connection is
correct.
• Continuous flash
of the start/can-
cel indicator light.
• 3 flashes of the
end indicator
light.
Malfunction:
The anti-flood de-
vice operates.
Close the water tap and contact your local After Sales Service.
Malfunction:
The programme
does not start.
The appliance door is not closed.
Close the door.
Mains plug is not connected in.
Put in the mains.
The fuse has blown out in the
household fuse box.
Replace the fuse.
After the check, switch on the appliance. The programme continues from the point of interrup-
tion. If the malfunction shows again, contact your After Sales Service.
ENGLISH
15