Laguna LE222 Maintenance Manual - page 10
PLAYLAGUNA.COM
Maintenance Manual
9
To change strings:
Thread the new strings through
the holes in the bottom of the bridge
and pull them up over the saddle.
Pull up across fretboard and string
through tuning machines.
String height at the bridge can
be adjusted by raising or lowering
the allen screws on either side of
each saddle.
LB224 and LB524
To change strings:
Loosen the locking nut using a
3 mm hex wrench.
One string at a time, loosen the
hex screw at the base of the saddle
to relax the small string holder pad.
Install the new string by cutting
the ball end off and placing in the
saddle. Then tighten the hex screw
until the holder pad is tight so the
string will not slip out. Run the string
up across the fretboard and string
through the tuning machine. Tune
string to pitch, then repeat for each
additional string.
To change strings:
Loosen the tension on your
current strings. Then, using a string
puller/peg winder, pull the bridge
pins from the bridge and remove
the strings.
Place the new string in the bridge
pin hole. Re-insert the bridge pin
while pulling the string to remove
any slack. Pull the string up across
the fretboard and thread through
the tuning machine. Hold the bridge
pins in place for each string while
tuning to pitch; this will eliminate
the bridge pins being pulled out of
place by string tension.
LE400Q, LE524
and LE924
All Acoustics
It is common for strings to slip and
stretch due to the increased tension
of the locking trem system. When all
strings have been replaced, stretch
each string thoroughly, tighten
the locking nut, and clip off any
excess string above the tuner.
Note: To fine tune strings after the
nut and bridge have been locked,
turn the bridge’s fine tuning screws
clockwise to raise pitch and counter-
clockwise to lower the pitch.