LAheli maxir 2008 User Manual - page 18
strana 17
Approximate values and measures
Lengths of rods are measured overall length end-to-end to make measuring easy
rod: lower cyclic plate servo lever
3x
31 mm
upper cyclic plate lever of blade holder
2x
45 mm
1) For first align flybars
-
Equal distance from the head (0,3 mm tolerance)
-
Neutral setup angle checked looking at mixer balls
2) Length of the rods between cyclic plate and servos should be set like: the servo
levers should be plumb when the collective pitch is 0° till +2°
3) All junctions must run smooth, but without noticeable play.
4) The flybar rod must be freely movable when touched by hand.
5) Check blades balance. If blades are misbalanced, use adhesive tape to correct
that.
6) Mark one blade with small (3×5 mm) patch of light adhesive tape with easily
visible color. You can than easily find which blade is running higher when setting
the blades alignment.
7) Position of tail servo on the boom is as both levers are perpendicular to pushrod
when tail pitch is about 30deg. The exact position is to be found during test
flights.
8) All moving joints should move freely, but without play.
-
The same danger you can cause, if you try to balance the vibration running
the machine without main blades.
Základní nastavení elektroniky
1) Serva a gyroskop p
ř
ipojíme do vstup
ů
p
ř
ijíma
č
e dle požadavk
ů
vysíla
č
e
(po
ř
adí kanál
ů
najdete v návodu k vysíla
č
i).
2) Všechna serva nastavíme tak, aby v klidových polohách m
ě
la páky kolmo.
3) Ve vysíla
č
i aktivujeme heli program s 120° ccpm systémem
ř
ízení.
4) P
ř
i naklán
ě
ní desky cykliky chodí protilehlá serva v protipohybu tak, aby
výška st
ř
edu desky v
ůč
i h
ř
ídeli z
ů
stala nezm
ě
n
ě
na.
5) P
ř
i zm
ě
nách kolektivního
ř
ízení náb
ě
hu list
ů
chodí serva souhlasn
ě
a desku
cykliky proti h
ř
ídeli posouvají nahoru/dol
ů
bez nakláp
ě
ní.
6) Nastavení regulátoru provedeme dle návodu k použitému regulátoru.
Electronics setup
1) Servos, controller and gyro connect to receiver channels according to
transmitter requirements (see TX instruction)
2) All servos should have levers in neutral position perpendicular
3) Transmitter should be set to CCPM 120deg mode
4) Check if the swashplate does not travel on the shaft when applying roll and
nick
5) Check if the swashplate moves up-down when changing pitch in parallel
6) Controller setup is described in controller instruction