Instruction manual 6-71-075-109 revision a autocirc ® instant hot water pump model: act e10
3 preparation for installation: assemble the parts and tools required: 1. Open and inspect autocirc pump package. 2. Autocirc pump package includes the pump with a built-in timer, a 6ft. Cord, and wall mounting bracket. 3. Two stainless steel flexible hoses (1/2” x 3/8”) - length as required. (sold ...
4 remove the existing flexible line connection to the hot and cold water faucet/tap threaded nipples (see fig. 3). (tip: mark the hot and cold water flexible lines to easily identify them). Note: if necessary, replace the existing flexible hoses with new stainless steel braided flexible hoses in the...
5 autocirc start up procedures timer controlled operation if timer controlled operation is desired, the timer may be programmed to allow the autocirc to operate during the hours desired (i.E. “on” from 7:00 a.M. To 9:00 p.M. And “off” from 9:00 p.M. To 7:00 a.M.) as follows: • open timer cover and r...
Xylem inc. 3878 s. Willow, suite 104 fresno, ca 93725 tel: (559) 265-4730 (800) 554-6853 fax: (559) 265-4740 (800) 453-7523 www.Xyleminc.Com/brands/laingthermotech laing thermotech is a trademark of xylem inc. Or one of its subsidiaries. © 2012 xylem, inc. 6-71-075-109a july 2012.
