Laird DVK-SU60-2230C User Manual - page 12
DVK-SU60-2230C Development Kit
User Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
12
© Copyright 2017 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
Default position of SW2 is to select regulated 5 volts.
The development board has a 1.8-volt regulator for the VCCIO of FTDI-Chip.
Figure 4: DVK-SU60-2230C power supply for VCCIO of FTDI chip
On the development board, the power domain:
▪ M2_3V3 supplies the M.2 module only.
▪ The header connectors (J3, J4, J5) can be used to measure the current of power domain M2_3V3.
▪ REG_1V8 supplies the FTDI chip IO only.
3.3 Tact Switch
3.3.1 The development board have three tact switches (SW5, SW6, SW7) for optional. To view its
location, refer to
Figure 1
.