Laird Field Fire LTM-FFP User Manual - page 3
800-898-0759 • 845-339-9555 • 2000 Sterling Road • Mount Marion, NY 12456 • www.lairdtelemedia.com
- Page 2 -
Component Video: Plug the proper component signals into the marked connec-
tors(R-Y, B-Y, Y). In component mode, a composite video signal synchronous to the
component signals must be fed to the REF BNC connector. This signal is required in
order for the component system to work. The video out signal of the component VTR
may be used for this.
Set the rear panel toggle switch to the UP position. This switch is a locking switch
and must be pulled slightly forward then moved up or down.
The front panel status LEDs power up default is DV mode. To switch to analog, push
the analog switch under the YUV-YC LEDs twice. This sets the LTM-FFP in component
Mode.
YC (S-video): Plug the proper 4pin Din into the YC input connector. Place the
rear panel toggle switch in DOWN position. Press the front panel analog switch
twice until YC/YUV LED illuminates.
NOTE: You cannot plug the YC and Component into the unit at the same time with
live signals. Do not leave the rear panel toggle switch in the incorrect mode
this will cause improper signals to be encoded.
Composite Video: Connect video signal to the BNC input connector. Press the ana-
log switch once till the CV LED illuminates.
NOTE: If ever the unit seems locked out of a particular mode: The DV button will
reset the system. Simply push the DV button and then return to analog pro-
cedures by pressing the ANALOG button. The video out BNC is always active.
It will display
the incoming video during analog-DV modes and will show
the decoded video during DV to analog playback.
(Continued on Page 3)
C
ONVERTING
A
NALOG
T
O
DV