Lakeair Excel (120v) Operating And Service Manual - page 2
UNPACKING AND OPERATING
INSTRUCTIONS
In order to operate your LakeAir Air Cleaner properly, it is necessary to remove
plastic packing material from the carbon after filter inside the unit and cardboard.
1. Unscrew and remove the two fasteners from
the top of the
cabinet.
2. Lift the cover assembly from the chassis and
set aside.
3. Remove the carbon after filter from behind
the cell. Take off the protective packing material, remove cardboard, and discard.
4. Replace the carbon after filter, then the cover assembly, making sure to include
both of the fasteners. NOTE: The fasteners must be in place and secured snugly or
the unit will not operate.
Place your LakeAir Air Cleaner in a convenient area in the desired room. If you are
using the air cleaner for a specific purpose, such as smoke removal, locate the air
cleaner as close as possible to the source. (Such as near a smoking stand.) Allow at
least 4-6” of unobstructed space behind the unit so that it will exhaust freely into the
room. If, however, you position the unit so that the airflow is parallel to the nearest
wall, you need not allow as much free space. For best results the unit should be
elevated by placing it on a table or stand. It can also be mounted on a wall, using our
convenient wall mount option.
OPERATING AND MAINTENANCE
INSTRUCTIONS
Position the unit and plug it into the proper
line voltage before turning it on.
1. To turn unit on, locate the three-
position rocker switch on top of the unit.
Depress the button to activate the unit on
the desired speed; High, Low, or Off
(center, flat position). Under normal
conditions, the Low position is adequate to
keep an average size room clean. With
excessive amounts of dust, smoke, or other
pollutants present, the air cleaner should be
operated on high.
2. To shut the unit off, simply push the
button to its center (flat) position.
NOTE
: It should be noted that
occasionally a large particle will pass
through the electronic cell and an arcing
will occur, resulting in an audible
cracking sound. This is normal and will
not cause any damage to the unit.
470004
40136
40137
20082 (120v)
21182 (230v)
or
20048 (120v)
21148 (230v)
495101
or
499052
497567
497612/497613
10064/10065/10064
or
10067/10066/10066
499086/499087
or
499088/499089
10072 (120v)
10172 (230v)
470067
10012 & 499049
499005
or
499027
40054
10011
or
10068
Part # Description Part
# Description
10068 Electronic
Filter Cell
10011
Electronic Filter Cell
499027
Carbon After Filter
499005
Carbon After Filter
10066
Cover Assembly– wood grain
10064
Cover Assembly– wood grain
10067
Cover Assembly-white
10065
Cover Assembly– white
10066 Black
Cover Assembly-black
10064 Black
Cover Assembly-black
20082
Motor 120v
20048
Motor 120v
21182
Motor 230v
21148
Motor 230v
499052
Fan Blade
495101
Fan Blade
499086 Grille-Black
499088 Grille-Black
499087 Grille-Grey
499089 Grille-Grey
Common Parts
10012 & 499049 Cell Contact Bracket
40136
Ion Wires w/ S-Hooks and Springs (6)
40054
Ion Connector Strap
470067
High Voltage Wire Jiffy Clip Fastener
470004
Ground Screw U-Clip
497613
Grey Rocker Switch
497572A
Voltage Doubler
497612
Black Rocker Switch
10072
Transformer 120v
470068
Knurled Fasteners
10172
Transformer 230v
40137
Ceramic Insulators w/ Screws (4/8)
497567 Micro
Switch
Plug the line cord into a standard household outlet with 120V AC 60 Hz. Caution
should be taken to use the unit only on the required voltage, as to do otherwise will
void the warranty.
EXCEL PARTS
MAXUM PARTS
Note:
Above items are available from your local LakeAir dealer.