Lakeland 14213 User Manual - page 4
ELECTRICAL CONNECTIONS
THIS APPLIANCE MUST BE EARTHED
This appliance is fitted with a fused three-pin plug to BS1363 which is suitable for use in all homes fitted
with sockets to current specifications. If the fitted plug is not suitable for your socket outlets, it should be
cut off and carefully disposed of. To avoid an electric shock, do not insert the discarded plug into a socket.
Fitting a new plug
If for any reason you need to fit a new plug, the flexible mains lead must be connected as shown here. The
wires in the mains lead fitted to this appliance are coloured in accordance with the following code:
Connect BLUE to Neutral (N)
Connect GREEN & YELLOW to Earth (E)
Connect BROWN to Live (L)
13 amp fuse to be used
If the colours of the wires in the mains lead of this appliance do not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows. The wire which is coloured green and yellow
MUST be connected to the terminal which is marked with the letter E (Earth) or coloured green. The wire
which is coloured blue MUST be connected to the terminal which is marked with the letter N (Neutral) or
coloured black. The wire which is coloured brown MUST be connected to the terminal which is marked
with the letter L (Live) or coloured red.
Before refitting the plug cover, check that there are no cut or stray strands of wire inside the plug. Use a 13
amp BS1362 fuse. Only BSI or ASTA approved fuses should be used. If you are at all unsure which plug or
fuse to use, always refer to a qualified electrician.
Note: after replacing or changing a fuse on a moulded plug which has a fuse cover, the cover must be
refitted to the plug; the appliance must not be used without a fuse cover. If lost, replacement fuse covers
can be obtained from an electrical shop. This appliance complies with the following EEC Directives: 73/23
EEC (Low Voltage Directive) and 89/336 EEC (EMC Directive).
CARE AND CLEANING
Always switch off and unplug the blender before cleaning. Remove the lid, then lift the jug off the power
unit and empty the contents.
Carefully remove the blade unit from the base of the jug by turning it clockwise, then lifting it out.
The jug, lid, filler cap, blade unit and sealing ring can all be washed in warm, soapy water, or in the
dishwasher. Please use a washing-up brush to protect your fingers from the sharp blades. Rinse all parts
thoroughly, and dry.
Fit the sealing ring back over the blade unit, then fit the blade unit back into the jug by turning it
anticlockwise until it locks into place.
Wipe the power unit with a dry cloth. Do not immerse in water or any other liquid, and do not use
abrasive cleaners or scourers as they will damage the product.
RECYCLING YOUR ELECTRICALS
Along with many other high street retailers, Lakeland has joined a scheme whereby customers can take
their unwanted electricals to recycling points set up around the country. Visit
www.recycle-more.co.uk
to
find your nearest recycling point.
E
Earth(green/yellow)
L
N
Neutral(blue)
1
3
a
m
p
F
U
S
E
13amp fuse
Live(brown)
0001
EXQ 1.5 Ltr
Blender 14213 IB B:Layout 1
9/4/10 19:03 Page 7