Lakeland 23307 User Manual - Getting Started
Getting Started
Assembly
1. Carefully unpack all the parts and remove any packaging. Do not plug in the mop until it is
fully assembled and you have read all of the following instructions.
2. Fig 1: Slide the upper extension tube (a) into the lower extension tube (b). Push the two
extension tubes together in until you hear them click into place.
3. Fig 2: Insert assembled pieces into the steam mop base. Push together until you hear it
click into place. Insert the cord into the cord clip on the shaft of the steam mop.
4. Fig 3: Place one microfibre pad underneath the mop head, with the quick fastener strips
facing up. Simply press the steam mop to the pad.
Filling the water tank
Please be aware that the first time you use the Lakeland Steam Mop you may find water
droplets in the water tank. This is due to testing of the unit at the factory.
1. Make sure your steam mop is unplugged from the wall before you fill the water tank.
2. Remove the water tank cap by turning it anti-clockwise to the unlocked position. The water
tank cap has an arrow to indicate the locked to unlocked position.
3. Use the jug and funnel to aid you in filling the water tank. The water tank must not be
filled above the max fill line.
4. Replace the water tank cap by turning it clockwise to the locked position.
Fig1.
Fig2.
Fig3.
a
b
5