Lakeland 24031 User Manual - Getting Started
6
Getting Started
Assembly
1. Carefully unpack all the parts and remove any packaging. Do not plug in the mop until it is
fully assembled and you have read all of the following instructions.
2. Fig 1: Slide the back saver handle (a) into the lower pole. Push the two tubes together until
you hear them click into place.
3. Fig 2: Insert the assembled pieces into the steam mop base. Push together until you hear it
click into place. Insert the cord into the cord clip on the shaft of the steam mop.
4. Fig 3: Place one microfibre pad underneath the mop head, with the quick fastener strips
facing up. Simply press the steam mop to the pad.
Filling the water tank
Please be aware that the first time you use the Lakeland Electronic Steam Mop you may find water
droplets in the water tank. This is due to testing of the unit at the factory.
1. Make sure your steam mop is unplugged from the wall before you fill the water tank.
2. Fig 4: Remove the water tank cap by turning anti-clockwise to the unlocked position.
3. Use the jug to aid you in filling the water tank. The water tank must not be filled above the
max fill line.
4. Replace the water tank cap by turning clockwise back to the locked position.
Fig 1.
Fig 2.
Fig 4.
Fig 3.
a
b