LAMBORGHINI Antares Quick Manual - page 3
4
3
PREPARING YOUR PHONE FOR FIRST USE
Inserting the SIM and Micro SD Card
1. To remove the Battery Cover, push theBattery Cover Release Latch
①
towards the top of the phone.
4. Insert the SD Card with the notch to the bottom left and the gold
contacts facing down. Slide the SD Card down, push it flat then slide
up such that the top of the SD Card is located under the top retaining
bar.
Inserting the Battery
The battery is supplied separately in the Sales Pack, to insert the battery follow the
instructions below.
1. Remove the Battery Cover if it is in place.
2. Discard any packaging from the battery.
3. Insert the battery with the Tonino Lamborghini Logo facing upwards,
putting the side of the battery with the contacts into the phone first so
that they connect to the contacts in the phone
①
.
4. Press the other edge of the battery gently into place so that the
battery is flat
②
.
5. Replace the Battery Cover.
If you need to remove the battery, there is a recess at the top
of the battery aperture that enables you to lift the battery out of
the phone more easily.
Dispose of batteries carefully. Do not dispose of the battery in
fire or water, but follow local regulations regarding disposal or
recycling.
Replacing the Battery Cover
1. Locate the two notches at the bottom of the Battery Cover (inside)
into the recesses on the bottom of your Antares phone
①
.
2. Gently press down onto the top of the Battery Cover until the Battery
Cover Latch clicks into place
②
.
Charging your Antares Phone
Please charge your Antares phone prior to first use.
Your Antares phone is provided with three adaptors that fit EU, UK and
US power sockets to enable you to charge your phone in many
locations worldwide.
Before charging your phone, connect the appropriate adaptor to the
charger body by sliding the socket adaptor into the charger body until
the retaining catch clicks into place.
To remove the socket adaptor from the charger body, depress the
retaining catch and slide the adaptor off the charger body.
2. Grip the sides of the Battery Coverand lift in the direction shown
②
3. Insert the SIM with the notched edge to the bottom right and the gold
contacts facing down.
Quick Guide
Quick Guide
①
②