Lamello Variocut Operating Instructions Manual - page 4
Safety instructions and liability
Please also read the enclosed general safety instructions carefully before putting your grooving machine
into service.
- When the grooving machine is not in use, before all servicing work, before changing the cutter, etc.: unplug the
cable!
- Ensure that the machine is switched off before inserting the plug in the socket.
- Check plug and cable for damage before inserting. If damage is found, replacement must be made immediately by
a technician.
- Make sure before starting the grooving machine that the rated voltage on the name-plate corresponds with the mains
voltage. The machine is only suitable for AC power supplies.
- The grooving machine is double-insulated and (conforming to CEE and VDE regulations) has a two-conductor cable
without ground conductor. The machine can be connected without risk to an ungrounded socket.
- Do not drill the motor case (e.g. to attach labels) since this damages the double insulation. Use only adhesive labels
for labelling.
- Clamp work tightly if possible and guide machine with both hands.
- Use only perfectly sharpened tools, since otherwise increased cutting forces may shift the work away.
- Do not stop the cutter after switching off.
- The machine should only be used for the applications described in these operating instructions.
- Do not expose to rain or use in damp locations.
- Manufacturer and retailer disclaim all product liability if the grooving machine is modified in any way from its original
state or condition as delivered, or if the grooving machine is used in a manner inconsistent with operating and safety
instructions.
EU-Declaration of Conformity
We declare under our sole responsibility that this product is in conformity with the following standards or normative
documents:
EN 55014, EN 60745-1, EN 61000 in accordance with the regulations of directives
73/23EWG, 98/37/EG, 89/336/EWG.
Sound emission and vibration acceleration
Typically A-weighted noise levels of the tool are:
Sound pressure level = 84 dB (A)
Sound power level = 95 dB (A)
Wear ear protection!
Typically the hand-arm vibration is below 5 m/s
2
.
English
Lamello AG
Wood Joining technology
Hauptstrasse 149
CH-4416 Bubendorf
K. Steiner
E.Zeller
Lamello AG: Domicile Bubendorf, Place of jurisdiction Liestal
Liable company: Lamello AG, Domicile Bubendorf, Place of jurisdiction Liestal
Owner: Mr. Karl Steiner, CEO: Mr. Erich Zeller
3