- DL manuals
- Lamona
- Scrubber
- HJA2180
- Installation & operating instruction
Lamona HJA2180 Installation & operating instruction
Summary of HJA2180
Page 1
60cm deluxe conventional extractor hja2180 stainless steel installation & operating instructions.
Page 2: Contents
Environmental note 2 important safety information 3 – 4 know your extractor 5 specifications 5 control panel 5 care and cleaning 6 - 8 the grease filters 7 changing a light bulb 7 fitting the carbon filter 8 installation 9 - 13 before beginning installation 9 extraction mode or recirculation mode? 1...
Page 3
Your safety is of the utmost importance; please make sure that you read this instruction booklet before attempting to install or use the appliance. Important: any installation work must be carried out by a qualified electrician or competent person. The hood must be installed in accordance with the i...
Page 4
Ensure the ducting for the extractor function has the same diameter as the outlet hole all the way through. Keep young children from using, playing with or tampering with the cooker hood. Older children and infirm persons should be supervised if they are using the cooker hood. Your cooker hood is fo...
Page 5: Dimensions:
5 82 120 600 150 500 dimensions: features: push button control operation 3 speed extraction 2 x 40w lights visor know your extractor ducted-out or recirculation modes 2 x metallic grease filter. 1 x carbon filter hja2906 (optional for recirculation mode only) specifications: max. Extraction capacity...
Page 6: Care And Cleaning
6 important: before cleaning, always ensure that you have switched your cooker hood off at the mains switch. Clean the external parts of your cooker hood with mild liquid detergent and a damp cloth. Never use abrasive powder, corrosive solvents or brushes. Never insert pointed objects into the motor...
Page 7: Changing Light Bulbs
Removing and cleaning the grease filters first remove the grease filters by pushing in the button on the handle and pulling the filter away from the cooker hood. Soak the grease filters in hot water and washing up liquid for at least 3 minutes. Then use a soft brush to loosen any grease deposits tha...
Page 8: Fitting The Carbon Filter
Fitting the carbon filter if the appliance is to be used in recirculation mode then it is necessary to fit a carbon filter. This will help to absorb unpleasant odours caused by cooking. Important: before attempting to fit or remove the carbon filter, you must ensure that you have disconnected the co...
Page 9: Installation
Installation 9 we recommend that at least two people install this hood. Important: your cooker hood should only be connected to your mains supply after completion of the installation process before beginning the installation check that the product purchased is of a suitable size for the chosen insta...
Page 10: Recirculation Mode
Ducted out or recirculating ? In ducted-out mode, the stale air will be taken out of the room via external ducting. In recirculation mode stale air is taken via the grease filter(s), and passed through a charcoal filter to remove odours. The air then re-enters the kitchen via an opening in the hood....
Page 11: Installation
Connecting to external ducting (ducted-out mode) important: to use the cooker hood in ducted-out mode, you must ensure that the adjuster which is behind the grease filter is set in the position shown. Important: the cooker hood can be ducted from the rear or from the top. The following steps should ...
Page 12: Installation
Installing your cooker hood (wall mounted) remove the grease filters (see page 7). Hold the hood against the wall in the intended position and mark the position of the screw holes that are to be drilled. Using an 8mm diameter drill, drill holes in the wall in these positions. Insert rawl plugs into ...
Page 13: Electrical Connections
Electrical connections 13 important: ensure that the electricity supply is switched off before connecting. Your appliance must be connected to fixed wiring via the use of a double pole switched fused spur outlet with at least 3mm contact separation, with a pilot lamp. The isolation switch must be ac...
Page 14
Important: if your cooker hood appears not to be operating correctly, please refer to the checklist below before contacting the customer service number. My extractor will not start. Check that the extractor hood is connected to the electricity supply check that the fan speed control is set correctly...
Page 15: Your Guarantee
This appliance is marked according to the european directive 2002/96/ec on waste electrical and electronic equipment (weee). By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health. The symbol on this product indica...