Lampo IP40 User Manual - page 3
2
Dimensions & weight
= 0,4 Kg
Technical data
- Aluminium
body
-
IP40 protection rate
-
Adjustable bracket, can be installed in any position
-
3 leds white XR-E 1.2W Xlamp by CREE
-
Approx. 10 years life (continued use)
-
Built-in RJ45 female connector
ATTENTION!!!
Connect the projector only to dedicated power unit.
Up to 20 meters total connection cable (series connection
with UTP straight patch cables
).
The power unit (LED POWER RGB) can drive up to 10 Mini Light Led.
Storage
The projector, in its original packing, must be kept in covered, dry areas with a temperature between –10°C and +50°C.
Attention, the projector will be damaged during the unpacking.
Admissible environmental conditions
The projector was engineered and produced to function in indoor areas with an air temperature ranging between -10° and
+30°C and with a humidity level between 30 and 90%.
When choosing the installation, please make sure that the device is not exposed to extreme heat or in small area.
If the projector is installed in hot area, led life is decreased.
Installation
The projector is designed to be installed on any materials and in any position.
Use the two hole, 6mm and 9mm, of the bracket for installing the projector.
Uncsrew the side handle and change the projector body angle.