Lampo IP67 LED Colour changer User Manual - page 3
2
Dimensions & weight
In-built RJ45 female connector, PG9 cable clamp
Technical data
- Aluminium
body
-
IP67 protection rate
- Plastic
house
- Walk
over
ATTENTION!!!
Connect the projector only to dedicated power unit.
Up to 20 meters total connection cable (series connection
with UTP straight patch cables
).
The power unit (LED POWER RGB) can drive up to 10 Mini Chic Led RGB.
Storage
The projector, in its original packing, must be kept in covered, dry areas with a temperature between –10°C and +50°C.
Attention, the projector will be damaged during the unpacking.
Admissible environmental conditions
The projector was engineered and produced to function in outdoor areas with an air temperature ranging between -20° and
+30°C and with a humidity level between 30 and 90%.
When choosing the installation, please make sure that the device is not exposed to extreme heat or in small area.
If the projector is installed in hot area, led life is decreased.
Installation
The projector is designed for in-ground installation. It is possible to walk on it.
The stainless steel ring has a 4mm maximum thickness.
Put sand and dredged gravel under the projector to ease the water drainage.