Lance TDC-100 Installation And Operation Manual - page 5
5
Quick Operation Guide - continued
To recall an in or out time to the display, press FCN, then MARK IN or MARK
OUT. The corresponding time value will be recalled to the display and the
scratchpad register, so you can do arithmetic with it if desired (add and subtract). If
you ‘double-click’ the REG # button it will recall the in time of the current register (or
clip name), for the currently-displayed machine. If there is no value stored in the
register, the display will be all asterisks, indicating no value.
To recall the stored clip name to the display, press FCN, then REG #. If there is
a stored clip name for the current device, it will be recalled to the second line of the
display, for the purpose of checking it.
To Trim an in time, recall time to display as above (FCN, MARK IN), press ‘+’ or ‘-’,
enter the trim value on the keypad, press SET, and press MARK IN to resave it.
Outtimes work the same way, with the MARK OUT key. You can set a known clip
duration the same way: recall the in time, press ‘+’, enter the desired duration, press
‘SET’, press ‘Mark Out’. This takes the in time, adds a duration value to it, and
stores it in the out register.
To display the duration of a register (difference between in point and out point),
press TM key. If either of the registers is clear, the display will be all asterisks,
indicating no value.
To manually learn a speed preset hold down the VAR button and press SET.
The display will confirm that the speed has been learned. This speed will be recalled
when the register is recalled. If you do a learn from the switcher, the current var
speed will be learned into the register.
To Cue Directly to a Keyed-In Time Value enter the time value on the keypad,
press ‘SET’, and press ‘CUE’. The device will cue to the entered time. The time
value will not be stored anywhere. Remember that you must press ‘SET’ before
pressing ‘CUE’. This validates the keypad entry before attempting to send the
machine to that position.
To Adjust TBC Levels press ‘FCN’, then ‘MENU’. This will put the controller into
the TBC adjust mode. Use the ‘+’ and ‘-’ keys to select the function, and the knob to
adjust. To exit this mode, press ‘FCN’ then ‘MENU’ again. The MENU button will
flash when in the TBC adjust mode. If there is no number value displayed after the
function, then the selected device does not support these commands.
(continued)