Specifications 1500 postmix dimensions width 19 3/16 inches (48.74 cm) depth 24 inches (60.96 cm) height (without legs) 25 3/8 inches (64.45 cm) weight shipping 150 pounds (68.2 kg) empty 130 pounds (59.0 kg) operating 220 pounds (99.8 kg) ice bank weight 30 pounds (13.6 kg) water bath capacity 12 g...
I specification 1500e postmix dimensions width 19 3/16 inches (48.74 cm) depth 24 inches (60.96 cm) height (without legs) 25 3/8 inches (64.45 cm) weight shipping 150 pounds (68.2 kg) empty 130 pounds (59.0 kg) operating 220 pounds (99.8 kg) ice bank weight 30 pounds (13.6 kg) water bath capacity 12...
Table of contents specifications 1500 postmix ...........................................................................................................Cover specifications 1500e postmix ...................................................................................................................
1. Installation 1.1 receiving each unit is completely tested under operating conditions and thoroughly inspected before shipment. At the time of shipment, the carrier accepts the unit and any claim for damages must be made with the carrier. Upon receiving units from the delivering carrier, carefully...
Equipped with electronic ice bank controls. D. Replace the yellow plug. E. Reinstall bonnet on dispenser. 1.6 connecting to electrical power warning this unit must be properly electrically grounded to avoid possible fatal electrical shock or serious injury to the operator. The power cord is provided...
C. Flush water supply line thoroughly. D. Route tubing through cutout in counter or through access hole in back of unit. E. Leave 12 inches (30 cm) of extra tubing length below the counter for servicing and moving the dispenser. F. Connect to desired plain water inlet behind splash plate and secure ...
4 2.5 yearly a. Clean water bath interior, including evaporator coils and refrigeration components. B. Clean the entire exterior of the unit. C. Sanitize syrup lines. 3. Dispenser cleaning and sanitizing 3.1 ambient process a. The ambient process is the most common method for cleaning and sanitizing...
4. Troubleshooting trouble cause remedy 4.1 water leakage around a. Damaged or improperly a. If damaged, replace. If improperly nozzle. Installed o-ring above diffuser. Installed, adjust. 4.2 leakage between upper a. Gap between upper and lower a. Tighten all six (6) retaining screws. And lower valv...
(section 4.8 continued from previous page.) b. Improper or inadequate water b. Remove valve from mounting block or syrup supply. And open shutoffs slightly and check water and syrup supply. If no supply, check dispenser for problems. Ensure bib connection is engaged. C. Kinked line. C. Remove kink o...
(section 4.15 continued from previous page.) c. Inadequate voltage. C. Measure voltage across common and run terminal on compressor. Voltage must not drop below 90% of rated voltage. D. Incorrect wiring. D. Refer to wiring diagram and correct. E. Defective condenser fan motor. E. Replace condenser f...
5. Illustrations, parts lists, and wiring diagrams 5.1 wiring diagram and control housing connections, electronic ice bank control, usa only 8 to valves 24 v leads ac power in agitator motor white black green kill switch jct compressor lancer ice bank control probe l relay s m m s fan motor c overlo...
9 w a t e r f l o w s f r o m t a n k o v e r f l o w t u b e . F il l w a t e r b a t h u n t il -i m p o r t a n t - w a t e r b a t h f il l h o l e bl bl/w bl/w bl to junction box 39 37 (to 32) 4 25 38 6 5 26 1 27 2 3 16 28f 19 (to 42) (to 18) 18 (to 11) 28g 17 43 23 9 44 15 30 41 29g 29 32 (to ...
Item part no. Description 1 30-5107 shroud, fan, bottom 2 30-5106 shroud, fan, top 3 04-0504 screw, 8 - 18 x 0.375 4 23-0985 condenser 5 47-0344 tube, process 6 23-0982 dryer/cap assy 7 25-0047 transformer, 115v/50-60hz 8 02-0041 seal 9 02-0040 seal, extrusion 10 11-0118 connector, ground 11 47-1269...
5.3 series 1500 refrigeration deck assembly, r-134a, with lancer electronic ice bank control (eibc); pn 82-2050e, 115v/60hz; pn 82-2099e, 230v/50hz; pn 82-2048e, 240v/60hz; export only 11 w a te r b a th f il l h o le -im p o r ta n t- fi ll w a te r b a th u n ti l ta n k o v e r fl o w t u b e . W...
Item part no. Description 1 30-5107 shroud, fan, bottom 2 30-5106 shroud, fan, top 3 04-0504 screw, 8 - 18 x 0.375 4 23-0985 condenser 5 47-0344 tube, process 6 23-0982 dryer cap assy 7 25-0048 transformer, 220v/50-60hz - 25-0047 transformer, 115v/50-60hz 8 02-0041 seal 9 02-0040 seal, extrusion 10 ...
3 29 2 1 32 31 7 6 11 8 9 10 27 16 33 34 23 24 22 18 20 19 21 13 15 17 15 14 12 5 37 25 26 36 35 4 6 30 28 8 5.4 series 1500 cabinet assembly, high performance 13.
Item part no. Description 1 30-0636/02 wrapper, external 2 51-0568 trim, gray 3 04-0067 rivet 4 50-0173 insulation, tape, front 5 50-0178 insulation, top 6 50-0214 insulation, tape, sides 7 50-0118 insulation, tape, back 8 04-0082 nut, hex, 10-24, ss 9 30-0612 back, plate 10 04-0477 screw, 8 - 32 x ...
27 23 5 4 6 4 7 2 32 12 33 34 35 22 1 24 12 12 30 31 12 20 19 12 13 11 26 21 3 28 11 8 29 14 17 18 16 15 14 10 9 25 6 5.5 series 1500e and 1500 premix cabinet assembly 15.
Item part no. Description 1 51-0744/01 wrapper, external 2 50-0173 insulation, tape, front 3 50-0178 insulation, top 4 50-0214 insulation, tape, sides 5 50-0118 insulation, tape, back 6 04-0082 nut, hex, 10 - 24, ss 7 42-0032 tank, foamed 8 04-0074 nut, clip 10 - 24 9 30-0624/01 front support plate ...
17 notes please refer to the lancer web site (www.Lancercorp.Com) for information relating to lancer installation and service manuals, instruction sheets, technical bulletins, service bulletins, etc..
