Lancia Y Owner's Handbook Manual - page 57
54
G
To close the bonnet:
1) Hold the bonnet up with one
hand and, with the other, remove rod
A (fig. 82) from recess C and replace
it in its clip B.
2) Lower the bonnet until it is about
20 cm (8 ins) above the engine com-
partment.
3) Let it fall: the bonnet closes auto-
matically.
Always make sure the
bonnet is closed properly
so it will not open while
travelling.
2) Lift lever B (fig. 81).
3) Lift the bonnet, and release the
support rod A (fig. 82) from its clip B.
4) Place the tip of the support rod in
recess C of the bonnet.
fig. 81
P4C00005
Important. The bonnet
might fall violently if the
support rod is not posi-
tioned properly.
Scarves, ties and loose
garmets can get caught in
moving parts. This can be
extremely dangerous.
fig. 82
P4C00006
If repairs need to be car-
ried out inside the engine
compartment when this is
still hot, be careful not to burn
yourself and keep away from the
electric fan as this may cut in at
any time, even if the key is re-
moved from the ignition switch.
Wait until the engine has cooled.
4C001-067 ING 11-03-2008 11:57 Pagina 54