Land Pride 326-364M Operator's Manual - page 17
15
Section 1: Assembly & Set-up
5/08/13
RCF2784 Rotary Cutters 326-364M
Table of Contents
Trail-Type Tongue Assembly
Figure 1-9
33268
6.
Attach parking jack (#29) to stob on tongue with
detent hitch pin (#30). Make certain detent hitch pin
is fully inserted.
Driveline Installation
Refer to Figure 1-9:
1.
Remove rubber protective sleeve (#25) from gearbox
input shaft and discard.
2.
Remove coupling bolt (#10) from end of slip-clutch.
3.
Unsnap one end of both access doors (#28) and
rotate doors open.
4.
Slide slip-clutch end of driveline onto gearbox input
shaft until holes in slip-clutch align with notch in
gearbox input shaft.
5.
Secure driveline (#27) to gearbox input shaft with
coupling bolt (#10), spring lock washer (#22), and
hex nut (#16). Tighten hex nut to the correct torque.
6.
Move slip-clutch back and forth several times to
make certain it is locked onto the gearbox shaft.
7.
Rotate access doors (#28) closed and snap in place.
8.
Insert jackshaft end of driveline (#27) through
bearing in bearing support assembly (#7).
9.
Pull bearing in bearing support assembly (#7)
against driveline (#27) and tighten set screw in
bearing collar against driveline jackshaft.
10. Attach driveline (#26) to jackshaft on driveline (#27)
by pulling back on pull collar (#31) and pushing yoke
onto the jackshaft. Release pull collar and continue
to push yoke forward until pull collar locks in place.
Pull-Type Cutter Assembly & Set-up
The following instructions are for assembling the
Pull-Type cutter. See page 9 for “3-Point Cutter
Assembly & Set-up” instructions.
Hitch Assembly
The tongue, drivelines, dual tailwheel axle, and ratchet
jack option or hydraulic cylinder option will need to be
assembled to the deck.
Refer to Figure 1-9:
1.
Discard 2 1/2" long bushing (not shown) shipped with
hitch pins (#3). Attach tongue (#9) to deck with hitch
pins (#3) and 1" long spacers (#6). Secure hitch pins
with linch pins (#23).
2.
With bearing lock collar facing driveline (#27), attach
bearing support assembly (#7) to tongue (#9) with
bushings (#8), flat washers (#20), lock washer (#21),
hex nut (#17), and 5/8"-11 x 7 1/2" GR5 hex head cap
screw (#12). Tighten hex nut to the correct torque.
3.
Attach spring hose loop mounting bracket (#5) to the
right-hand clevis with 3/8" -16 x 1" GR5 hex head cap
screw (#13) and lock nut (#18). Tighten lock nut to
the correct torque.
4.
Attach spring hose loop (#24) to spring hose loop
mounting bracket (#5) with 3/8" -16 x 1" GR5 cap
screw (#11), flat washer (#19), and lock nut (#15)
Tighten lock nut to the correct torque.
5.
Attach parking jack support stob (#4) to the left-hand
clevis lower hole with 3/4"-10 x 1 3/4" GR5 hex head
cap screw (#14) and lock nut (#18). Tighten lock nut
to the correct torque.
IMPORTANT: Be sure bearing lock collar in bearing
support assembly (#7) is facing driveline (#27).