Land Pride Electric Lift Actuator 322-119A Installation Instructions

1

© Copyright 2005

Printed

Before You Start

Your Land Pride Electric Actuator is exclusively

designed for your Land Pride FPS48 Food Plot Seeder.

Please read these installation instructions and the Food

Plot Seeder Operator’s Manual thoroughly before

beginning. Especially read information relating to safety

concerns. Also included in the Operator’s Manual is

important information on operation, adjustment,

troubleshooting, and maintenance for this attachment

(some manual sections do not apply to all accessories).

A separate Parts Manual for replacement parts can be

purchased from your dealer or available free of charge at

www.landpride.com. Have model and serial numbers

handy when placing an order.

Manual Part Numbers:

• Operator’s Manual . . . . . . . . . . . . . . . . . 322-118M

• Parts Manual . . . . . . . . . . . . . . . . . . . . . 322-118P

General Information

These assembly instructions apply to the following

Electric Actuator Accessories listed below:

322-119A

ELECTRIC LIFT ACTUATOR PACKAGE

Tools required:

•

Safety Glasses

•

Work Gloves

Assembly Instructions

A detailed listing of parts for the accessory kit is provided

on page 3. Use the list as a checklist to inventory parts

received. Please contact your local Land Pride dealer for

any missing hardware.

Linear Actuator

 Installation

Refer to Figure 1-1:

1.

Park the Food Plot Seeder on a flat level surface.

When you see this symbol, the subsequent

instructions and warnings are serious - follow

without exception. Your life and the lives of

others depend on it!

!

IMPORTANT: Before you begin, read these

instructions and check to be sure all parts and tools

are accounted for. Please retain these installation

instructions for future reference and parts ordering

information.

2.

Adjust ratchet jack to lower the FPS48 disc gangs

onto the ground until all pressure is removed from

the clevis pins. Remove ratchet jack from the seeder.

3.

Attach lower end of linear actuator (#3) to the front

mounting lug (B) with hitch pin (#2). Secure in place

with hair pin clip (#1).

4.

Attach hand controller (#4) to the linear actuator by

plugging connector (E) into connector (F).

Linear Actuator Assembly ()

Figure 1-1

Refer to Figure 1-2 on page 2:

!

CAUTION

Make sure all electrical wiring is supported in such a way that

it will not come in contact with trash, lift mechanism, rotating

discs, pinch points, vehicle rotating components, hot exhaust

components, etc.

23907

For Model FPS48 Plot Ranger

Electric Lift Actuator

For Food Plot Seeder

4/17/06

Manual No. 322-121M