Land Pride OS1548 Operator's Manual - page 15
13
Section 1: Assembly & Set-up
2/29/12
OS1548 and OS1572 Overseeder (S/N 166724+) 308-303M
Table of Contents
PTO Driveline Shortening
Figure 1-10
3.
If measurement is acceptable (1" or more), skip to
“Check Driveline Maximum Length” on this page. If
measurement is less than 1", then shorten driveline
using instructions provided below.
Shorten Driveline
Refer to Figure 1-10:
1.
Un-hook driveline from tractor PTO shaft and pull
outer and inner drivelines apart.
2.
Reattach outer driveline to tractor PTO shaft. Pull on
inner and outer drivelines to be sure universal joints
are properly secured.
3.
Hold inner and outer drivelines parallel to each other:
a. Measure 1" (“B” dimension) back from outer
driveline universal joint shield and make a mark at
this location on the inner driveline shield.
b. Measure 1" (“B” dimension) back from the inner
driveline universal joint shield and make a mark at
this location on the outer driveline shield.
4.
Remove driveline from tractor and gearbox shafts.
5.
Measure from end of inner shield to scribed mark
(“X” dimension). Cut off inner shield at the mark. Cut
same amount off the inner shaft (“X1” dimension).
6.
Measure from end of outer shield to scribed mark
(“Y” dimension). Cut off outer shield at the mark. Cut
same amount off the outer shaft (“Y1” dimension).
7.
Remove all burrs and cuttings.
8.
Continue with “Check Driveline Maximum Length”.
22227
Check Driveline Maximum Length
Refer to Figure 1-11:
Make sure driveline collapsible length is acceptable. If
needed, refer to “Check Driveline Collapsible Length”
instructions on page 12.
The driveline maximum allowable length must, when fully
extended, have a minimum overlap of the profile tubes by
not less than 1/3 the free length with both inner and outer
profile tubes being of equal length.
1.
Driveline should be unhooked from tractor PTO shaft
with the outer and inner drivelines pulled apart as
shown in Figure 1-10.
2.
Apply multi-purpose grease to the inside of the outer
profile tube and then reassemble the two driveline
halves together with just 1/3 overlapping of the
profile tubes as shown below. Once assembled,
measure and record maximum allowable length for
future reference.
Driveline Maximum Extended Length
Figure 1-11
3.
Attach inner driveline yoke to the gearbox shaft.
Attach outer driveline yoke to the tractor PTO shaft.
4.
Move yoke ends of driveline back and forth to insure
they are secured. Reattach any end that is loose.
5.
Continue with “Hook-up Driveline Safety Chains”
below.
Hook-up Driveline Safety Chains
6.
Hook driveline safety chain on the tractor end of
driveline to the tractor. Re-latch safety chain to the
driveline shield.
7.
Hook driveline safety chain on the Overseeder end of
driveline to the seeder frame. Re-latch safety chain
to the driveline shield.
8.
Continue with “Check Driveline Interference” on
page 14.
24513
Outer Shielding has been removed for clarity.
IMPORTANT: Two small chains are supplied with
the driveline. To keep driveline shields from rotating,
these chains must be attached to the outer and inner
driveline shields and to the seeder and tractor.