Land Pride REAR BLADES RBT55120 Operator's Manual - page 14
12
Section 2: Options, Assembly & Set-Up
RBT55120 Rear Blades 301-172M
5/21/07
Land Pride
Table of Contents
Manual Offset, Angling and Tilting
The manual links and ratchet jack may be used in place
of the hydraulic cylinders.
Manual Blade Angling
Refer to Figure 2-4:
7.
Attach blade angling links (#3 and #4) to the right
side of the Rear Blade as shown with two 1" clevis
pins (#1). Secure with hair pin cotters (#5).
8.
Adjust blade angle by removing hitch pin (#2) and
moving outer link (#3) to a different hole. Replace
hitch pin and secure with hair pin cotter (#5).
IMPORTANT: Do not remove shipping block from
the blade tilt housing until all cylinders and/or ratchet
jack and manual links have been installed.
Manual Offset, Angling and Tilting
Figure 2-4
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.
Blade Angling
Blade Offset
Blade Tilting
25508
Manual Blade Offset
Refer to Figure 2-4:
9.
Attach blade offset links (#3 and #4) to the left side
of the Rear Blade as shown with two 1" clevis
pins (#1). Secure with hair pin cotters (#5).
10. Adjust offset angle by removing hitch pin (#2) and
moving outer link (#3) to a different hole. Replace
hitch pin and secure with hair pin cotter (#5).
Manual Blade Tilting
Refer to Figure 2-4:
1.
Attach ratchet jack (#6) to the back side of the Rear
Blade as shown with two 1" clevis pins (#1). Secure
with hair pin cotters (#5).
2.
Adjust blade tilt by setting the lock on the ratchet
lever and pumping the lever back and forth to raise
one end of the blade higher than the other end.
Reposition ratchet lock and pump lever back and
forth to tilt blade in the opposite direction.
3.
Remove shipping block after ratchet jack (#6) has
been installed.