Landa HOT 2-1100 Operator's Manual

Other manuals for HOT 2-1100: Operator's Manual, Service Manual
Manual is about: HOT series

Summary of HOT 2-1100

  • Page 1

    8.917-208.0 operator’s manual for technical assistance or the landa dealer nearest you, consult our web page at www.Landa.Com hot ■ hot 2-1100 ■ hot2-1500 ■ hot 4-2000 ■ hot 3-1100 ■ hot 3-300 89172080-1.

  • Page 2: Contents

    3 contents model number ______________________________ serial number ______________________________ date of purchase ___________________________ the model and serial numbers will be found on a decal attached to the pressure washer. You should record both serial number and date of purchase and keep i...

  • Page 3: Important Safety

    8.917-208.0 • hot operator manual • rev. 03/12 opera t or’s manu al pressure w asher 4 introduction & important safety information thank you for purchasing this pressure washer. We reserve the right to make changes at any time without incurring any obligation. Owner/user responsibility: the owner an...

  • Page 4: Important Safety Information

    8.917-208.0 • hot operator manual • rev. 03/12 5 pressure w asher opera t or’s man u al risk of injection or severe injury to persons. Keep clear of nozzle. Warning warning: high pressure devel- oped by these machines will cause personal injury or equip- ment damage. Keep clear of nozzle. Use cautio...

  • Page 5: Component Identification

    8.917-208.0 • hot operator manual • rev. 03/12 opera t or’s manu al pressure w asher 6 89172080-2 component identification detergent injector discharge nipple quick coupler collar garden hose inlet connector steam hose stackless top adapter kit (optional 8.903-430.0) high pressure nozzle detergent p...

  • Page 6: Installation

    8.917-208.0 • hot operator manual • rev. 03/12 7 pressure w asher opera t or’s man u al installation place machine in a convenient location providing am ple support, drainage and room for maintenance. These machines are designed for indoor use. They must be stored indoors when not in use. Location: ...

  • Page 7: Assembly Instructions

    8.917-208.0 • hot operator manual • rev. 03/12 opera t or’s manu al pressure w asher 8 assembly instructions step 1: connect the power cord into the proper electrical out - let, then push in the gfci reset button. (re fer to se ri al plate for information.) step 2: connect high pressure hose to disc...

  • Page 8: Operation Instructions

    8.917-208.0 • hot operator manual • rev. 03/12 9 pressure w asher opera t or’s man u al 89172080-12 operation instructions step 1: stop! Read opera- tor’s manual before operating this ma chine. Failure to read operation and warn ing in struc tions may re- sult in personal in ju ry or prop er ty dama...

  • Page 9: Thermal Pump Protection

    8.917-208.0 • hot operator manual • rev. 03/12 opera t or’s manu al pressure w asher 10 warning: some de ter gents may be harm ful if in haled or in gest ed, caus ing severe nau - sea, fainting or poi son ing. The harm ful el e ments may cause prop er ty dam age or severe in ju ry. Step 1: use deter...

  • Page 10: Shutting Down and Clean-Up

    8.917-208.0 • hot operator manual • rev. 03/12 11 pressure w asher opera t or’s man u al 89172080-15 shutting down and clean-up caution: al ways store your pressure washer in a lo ca tion where the temperature will not fall be low 32°f (0°c). The pump in this machine is sus cep ti ble to per ma nent...

  • Page 11: Maintenance & Service

    8.917-208.0 • hot operator manual • rev. 03/12 opera t or’s manu al pressure w asher 12 maintenance & service preventative maintenance 1. Check to see that water pump is properly lu bri - cat ed. 2. Follow winterizing procedures to prevent freeze dam age to pump and coils. 3. Always neutralize and f...

  • Page 12: Maintenance & Service

    8.917-208.0 • hot operator manual • rev. 03/12 13 pressure w asher opera t or’s man u al maintenance & service step 3 attach a short section (3-5 ft.) of garden hose to machine to siphon solution from an el e vat ed con tain er. Turn machine on, allowing solution to be pumped through coils back into...

  • Page 13: Maintenance & Service

    8.917-208.0 • hot operator manual • rev. 03/12 opera t or’s manu al pressure w asher 14 moved to allow the air to fl ow through the burner. Sharp eye-burn ing white fumes indicate too much air fl owing through the com bus tion chamber. The air band should be moved to al low less air to fl ow through...

  • Page 14: Preventative Maintenance

    8.917-208.0 • hot operator manual • rev. 03/12 15 pressure w asher opera t or’s man u al preventative maintenance oil change record this pressure washer was produced with the best avail able ma te ri als and quality craftsmanship. However, you as the own er have certain re spon si bil i ties for the...

  • Page 15: Troubleshooting

    8.917-208.0 • hot operator manual • rev. 03/12 pressure w asher t roub leshooting guide 16 troubleshooting problem possible cause solution low operating pressure faulty pressure gauge install new gauge. Insuffi cient water supply use larger garden hose; clean fi lter washer at water inlet. Old, worn...

  • Page 16: Troubleshooting

    8.917-208.0 • hot operator manual • rev. 03/12 17 pressure w asher t roub leshooting guide troubleshooting problem possible cause solution fluctuating pressure valves worn check and replace if necessary. Blockage in valve check and replace if necessary. Pump sucking air check water supply and air se...

  • Page 17: Troubleshooting

    8.917-208.0 • hot operator manual • rev. 03/12 pressure w asher t roub leshooting guide 18 troubleshooting problem possible cause solution burner light will not light disconnected or short in electrical wiring all wire contacts should be clean and tight. No breaks in wire. Burner motor thermal prote...

  • Page 18

    8.917-208.0 • hot operator manual • rev. 03/12 pressure w asher w arranty landa limited new product warranty pressure washers what this warranty covers all landa pressure washers are warranted by landa to the original purchaser to be free from defects in materials and workmanship under normal use, f...

  • Page 19

    Form #8.917-208.0 • revised 03/12 • printed in u.S.A..