- DL manuals
- Landa
- Pressure Washer
- PGA3-27324
- Operator's Manual
Landa PGA3-27324 Operator's Manual
Summary of PGA3-27324
Page 1
■ pga3-27324 ■ pga4-35324 pga operator’s manual 8.917-988.0 to locate your local landa commercial pressure washer dealer nearest you, visit www.Landa.Com.
Page 3: Contents
3 contents model number ______________________________ serial number ______________________________ date of purchase ___________________________ the model and serial numbers will be found on a decal attached to the pressure washer. You should record both serial number and date of purchase and keep i...
Page 4: Important Safety
Pga • 8.917-988.0 • rev. 10/12 opera t or’s manu al pressure w asher 4 introduction & important safety information thank you for purchasing this pressure washer. We reserve the right to make changes at any time without incurring any obligation. Owner/user responsibility: the owner and/or user must h...
Page 5: Important Safety Information
Pga • 8.917-988.0 • rev. 10/12 5 pressure w asher opera t or’s manu al important safety information warning keep water spray away from electrical wiring. Warning: keep wand, hose, and water spray away from electric wiring or fatal electric shock may result. 9. Do not spray water on or near electrica...
Page 6: Important Safety Information
Pga • 8.917-988.0 • rev. 10/12 opera t or’s manu al pressure w asher 6 important safety information 18. Do not operate this machine when fatigued or under the infl uence of alcohol, prescription medications, or drugs. 19. Inlet water must be clean fresh water and no hotter then 90°f. 20. Manufacture...
Page 7: Component Identification
Pga • 8.917-988.0 • rev. 10/12 7 pressure w asher opera t or’s manu al pump — develops high pressure. Starter grip — used for starting the engine manu- ally. Spray gun — controls the application of water and detergent onto cleaning surface with trigger device. Includes safety latch. Unloader valve —...
Page 8: Assembly Instructions
Pga • 8.917-988.0 • rev. 10/12 opera t or’s manu al pressure w asher 8 assembly instructions step 1: adjust handle at the de- sired position. Step 2: attach the high pressure hose to the spray gun using tefl on tape on hose threads. Step 5: release the coupler collar and push the nozzle until the co...
Page 9: Operating Instructions
Pga • 8.917-988.0 • rev. 10/12 9 pressure w asher opera t or’s manu al operating instructions step 1: check engine oil level. Oil level should be level with the bottom of the oil fi ller neck. Be sure the machine is level when checking the oil level. (refer to the engine's operating manual included ...
Page 10: Operating Instructions
Pga • 8.917-988.0 • rev. 10/12 opera t or’s manu al pressure w asher 10 step 8: turn the engine switch to "on" position. On vanguard engines, move the throttle lever to "fast" position, shown on the engine as a rabbit. Step 9: pull the starter grip. If the engine fails to start after 2 pulls, squeez...
Page 11: Thermal Pump Protection
Pga • 8.917-988.0 • rev. 10/12 11 pressure w asher opera t or’s manu al warning: some detergents may be harmful if inhaled or in- gested, causing severe nausea, fainting or poisoning. The harm- ful elements may cause property damage or severe injury. Step 1: connect the optional detergent injector t...
Page 12: Shutting Down and Clean-Up
Pga • 8.917-988.0 • rev. 10/12 opera t or’s manu al pressure w asher 12 shutting down and clean-up step 1: remove detergent suc- tion tube from container and insert into one gallon of fresh water. Slide nozzle forward for low pressure or to connect black detergent nozzle. Pull trigger on spray gun a...
Page 13: Storage
Pga • 8.917-988.0 • rev. 10/12 13 pressure w asher opera t or’s manu al caution: always store your pressure washer in a location where the temperature will not fall below 32°f (0°c). The pump in this machine is susceptible to permanent damage if frozen. Freeze damage is not covered by warranty. 1. S...
Page 14: Troubleshooting
Pga • 8.917-988.0 • rev. 10/12 pressure w asher t roub leshooting guide 14 troubleshooting problem possible cause solution low operating pressure faulty pressure gauge install new gauge. Insuffi cient water supply use larger supply hose; clean fi lter at water inlet. Old, worn or incorrect spray noz...
Page 15: Troubleshooting
Pga • 8.917-988.0 • rev. 10/12 15 pressure w asher t roub leshooting guide troubleshooting problem possible cause solution water or oil leaking from bottom of pump a small amount of leaking is normal if excessive leaking occurs, call local distributor. Presence of water in pump oil water sprayed at ...
Page 16: Preventative Maintenance
Pga • 8.917-988.0 • rev. 10/12 pressure w asher t roub leshooting guide 16 preventative maintenance this pressure washer was produced with the best available materials and quality craftsmanship. However, you as the owner have certain responsibilities for the correct care of the equipment. Attention ...
Page 17: Hose & Spray Gun Assembly
Pga • 8.917-988.0 • rev. 10/12 17 pressure w asher opera t or’s manu al hose & spray gun assembly hose & spray gun assembly parts list 1 2 3 5 item part no. Description qty 1 8.916-740.0 hose, 3/8" x 50', 1 wire tuff-skin (bga models) 1 8.739-011.0 hose, 3/8" x 50', 1 wire tuff-skin (bxa models) 1 8...
Page 18: Oil Change Record
Pga • 8.917-988.0 • rev. 10/12 opera t or’s manu al pressure w asher 18 date oil changed month/day/year estimated operating hours since last oil change date oil changed month/day/year estimated operating hours since last oil change oil change record check pump oil and engine oil level before fi rst ...
Page 19
Pga • 8.917-988.0 • rev. 10/12 pressure w asher w arranty 19 landa limited new product warranty pressure washers what this warranty covers all landa pressure washers are warranted by landa to the original purchaser to be free from defects in materials and workmanship under normal use, for the period...
Page 22
Form #8.917-988.0 • pga • revised 10/12 • printed in u.S.A. Or mexico.