Landa ZE2-11026D Operator's Manual - Assembly Instructions
ZE/ZEF-ET-HD-HE • 8.914-001.0, 8.941-457.0, 9.800-088.0, 8.919-017.0 • Rev. 12/12
7
PRESSURE W
ASHER
OPERA
T
OR’S MANU
AL
ASSEMBLY INSTRUCTIONS
STEP 1: Attach the high pressure
hose to the spray gun with quick
coupler.
STEP 4: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 6: Connect the high pressure
hose to the pump discharge fi tting.
Push coupler collar forward until
secure.
STEP 2: Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
STEP 3: Pull the spring-loaded col-
lar of the wand coupler back to insert
your choice of pressure nozzle.
STEP 7: Connect the garden hose
to pump inlet. Inspect inlets.
CAUTION: Do not run the pump
without water or pump damage
will result.
Safety
Latch
Spray
Gun
High
Pressure Hose
Nozzle
Extension
Spray Gun/
Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Pump Discharge
Fitting
High
Pressure
Hose
Pump Water Inlet
Garden
Hose
Coupler
Collar
STEP 5: Remove shipping cap and
install oil dipstick. Check pump oil
level by using dipstick. Use 40 wt.
non detergent oil.
Dipstick