Landis & Gyr Cashpower Gemini PLC User manual - page 13
Customer Interface Unit LCD Released
13/38
Cashpower Gemini PLC
– User Guide
© Landis+Gyr (Pty) Ltd
6.3
Happy and Sad Faces
These two icons are used in combination to give a quick visual indication of good and bad status. For
example, if the meter is operating normally, the happy face will be on. However, if it is tampered, the
sad face will come on. Similar responses apply during entry of the prepayment voucher e.g. entering
an invalid voucher will result in the sad face flashing for a short period of time. Note that an out of
credit con
dition is not considered to be a 'bad‟ status and the happy face will be on.
6.4
Alarm Indicator
This is a „low credit‟ warning indicator that turns on if the current credit register value is greater than
zero, but less than half the low credit level. Under these conditions it is displayed in conjunction with
the smallest credit wedge icon
– 11.9.
6.5
Load Switch Status Indicator
This icon indicates the status of the load-switch. If it is closed, electricity is supplied to the customer. If
it is open, the custom
er‟s electricity supply is disconnected.
Under normal operating conditions e.g. with the meter in credit, the load switch will be closed. It will
open when credit expires.
6.6
Remaining Credit Indicator
This 4-
segment „wedge‟ provides a quick visual indication of the remaining credit in the meter and
functions as follows:
All four credit wedge icons are displayed if the value in the credit register is above the preset
high credit level.
The three smallest wedge icons are displayed if the value in the credit register is somewhere
between the preset low credit level and high credit level.
The two smallest wedge icons are displayed if the value in the credit register is somewhere
between the preset low credit level and half of that level.
The smallest wedge icon is displayed if the value in the credit register is somewhere between
zero and half of the preset low credit level.
All the credit wedge icons will be off when the meter runs out of credit (zero or negative values).
NB: The actual credit levels at which th
e individual bars in the „wedge‟ icon toggle are personalised at
the time of manufacture but can be changed at any time with an engineering voucher from the
prepayment vending system.
6.7
Information Mode Indicator
This icon turns on in response to pressing the information key on the keypad. It indicates that the
meter is in information mode and the contents of various registers can be viewed
– 11. Note that the
information mode automatically times out after a period of 1 minute in the absence of any further
interrogation.
6.8
Credit Metering Mode Indicator
This icon is displayed in conjunction with the kWh indicator 6.9 to indicate clearly when the meter is
operating in credit metering mode.
6.9
Power (kWh) Indicator
This icon is ON whenever the displayed units represent power (kWh). It applies to both the normal
meter operating mode as well as when viewing registers via the information mode.
The power (kWh) icon will also flash on and off if no measurable energy is being consumed.