Landis & Gyr FOCUS kWh Technical Manual - page 10
4
3. Meter
Assembly
3.1.
Removal of the Electronics Housing from the Baseplate
To remove the Electronics Housing from the baseplate, set meter on a solid surface and place hands around
the bottom of the gray housing where it meets with the baseplate. With thumbs in the 6 o’clock position,
squeeze firmly with thumbs using considerable force, to flex the housing and release the bottom two
fasteners located at the 4 o’clock and 8 o’clock positions. It may be necessary to alternate pressure by
thumbs until both fasteners are released. Once these two fasteners are released, push gently toward the 12
o’clock position to release the top two fasteners. The housing can be lifted off and the blue and white power
connector can be unplugged.
3.2.
Installation of the Electronics Housing onto the Baseplate
Before installing the Electronics Module onto the Baseplate, make sure that the Electronics Module and
Baseplate are free of foreign debris and that any cables are properly routed to prevent interference with the
meter’s electrical connectors. Attach blue and white power connector. Line up the 4 slots in the gray
electronics housing with the 4 mating snap-on protrusions located on the black baseplate. Once aligned,
apply gentle force to snap the two assemblies together.
3.3.
Sealing the Meter
The
FOCUS
meter comes standard with T-seal provision.
Whether to seal the meter or not is left to the user’s discretion.
If sealing is desired, T-seals can be installed through the
FOCUS
cover and baseplate assembly.