B laney series 1/2/3 user manual v1.
Laney care of your laney amplifier will prolong it's life.....And yours!. After unpacking your amplifier check that it is factory fitted with a three pin 'grounded' (or earthed) plug. Before plugging into the power supply ensure you are connecting to a grounded earth outlet. If you should wish to ch...
Important safety instructions warning: when using electric products, basic cautions should always be followed, including the following. 1. Read all safety and operating instructions before using this product 2. All safety and operating instructions should be retained for future reference 3. Obey all...
B1-2-3 front panel laney 3 3 8 passive input : high impedance input for instruments with normal output i.E. Lower output level. Active input : low impedance input with half the input sensitivity of the passive input for instruments with an active circuitry and high output levels. As there are so man...
9 10 11 12 14 bright switch : the bright switch allows the user to boost the whole frequency response of the pre amplifier from mid range upward by 6db. This allows the player to mimic plugging into the bright channel on an old style tube bass amplifier. Pre shape: this allows a pre determined eq cu...
Laney 5 5 b1 rear panel - see p7 for b2/b3 differences power input : socket for connecting mains plug. Reset button : should the unit be connected in error and experience a continuos overload situation such as connecting the unit to an incorrect supply voltage or should the amplifier experience a ca...
Laney 6 6 32 active crossover level : this control sets the level of hi signal sent to the amp1/hi output speaker socket (28).Along with the level of signal appearing at (32) it should be used to balance the level of the high frequency cabinet, a 4 x 10 cabinet for example against the level of the s...
Laney 7 7 b2/b3 rear panel 91 27 90 26 internal/hi : speaker connector to the two internal 10“ loudspeakers. The type of signal present at this speaker connector varies, depending upon the selected mode of operation for the power amplifier. When the amp mode selector is set to internal+sub, this spe...
Laney 8 8 specifications b series manual input sensitivity : active -18dbu (90mv) 1m ohm (fet channel) passive -13dbu (150mv) 150k ohm input sensitivity : active -46dbu (4mv) 1m ohm (tube channel) passive -40dbu (10mv) 150k ohm tuner : input level -6dbu di output : xlr balanced pre/post eq (0dbu) ax...
Laney 9 9 system diagram system diagram laney b series manual b series manual.
Blt industries ltd., newlyn road, cradley heath, west midlands. B64 6be. Tel: (0044) (0)1384 633821 fax: (0044) (0)1384 639186 http://www.Laney.Co.Uk in the interest of continued product development blt industries ltd. Reserves the right to amend product specification wihtout prior notification..
