Laney CUB 12 Operating Instructions Manual

Summary of CUB 12

  • Page 1

    Opera ting instr uctions - 1.2 cub 2.

  • Page 2: Cub

    Laney important safety instructions page 2 / 16 warning: when using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions safe. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near...

  • Page 3: Cub

    Laney page 3 / 16 instructions importantes de securite - franÇais attention: l’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce ma...

  • Page 4: Cub

    Page 4 / 16 laney achtung: beim einsatz von elektrogeräten müssen u.A. Grundlegende vorsichtsmaßnahmen befolgt werden: 1. Lesen sie sich diese anweisungen durch. 2. Bewahren sie diese anweisungen auf. 3. Beachten sie alle warnungen. 4. Befolgen sie alle anweisungen. 5. Setzen sie dieses gerät nicht ...

  • Page 5: Cub

    Cub 2 cuidado: cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: 1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6. Limpiar solamente c...

  • Page 6: Cub

    Page 6 / 16 laney after unpacking your amplifier check that it is factory fitted with a three pin 'grounded' (or earthed) plug. Before plugging into the power supply ensure you are connecting to a grounded earth outlet. If you should wish to change the factory fitted plug yourself, ensure that the w...

  • Page 7: Cub

    Cub 2 specifications laney page 7 / 16 nominal supply voltage ~100v, ~115v, ~220v, ~230v, 50/60hz power consumption 50w output power rating 15w loudspeaker input impedance 1mohm size (h*w*d) 427*435*235 unit weight operating voltage factory set celestion custom driver 8 ohm loudspeaker outputs exten...

  • Page 8: Cub

    Dear player, thank you very much for purchasing your new laney product and becoming part of the worldwide laney family. Each and every laney unit is designed and built with the utmost attention to care and detail, so i trust yours will give you many years of enjoyment. Laney products have a heritage...

  • Page 9: Cub

    Cub 2 introduction laney page 9 / 16 the cub12 is a straight forward easy to use tube combo amplifier, featuring 3 x ecc83/12ax7 preamp tubes and 2 x el84 output tubes. Its 15w class a/b push/pull circuitry pumps out classic tube tones through a 12" celestion speaker. The chocolate brown front panel...

  • Page 10: Cub

    Tour of the controls & features page 10 / 16 laney 6 5 4 3 2 1 7 power switch: main power switch for the unit. Tube amplifiers take between 30 seconds and 2 minutes to warm up and be ready to play after switching on, this is normal. The tone control works in a similar fashion to the tone control you...

  • Page 11

    Page 11/ 16 12 10 11 12 15 13 14 11 15 uses the amplifier in full power mode. Input: plugging in to this input switches the output power stage down to around 1w. (use this feature for recording or bedroom playing). (always switch off and disconnect the power cord when not in use). Serial no: display...

  • Page 12: Cub

    Laney tube amplifier survival tips • tube amplifiers; generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect due to the fragile glass tubes themselves. The uses top quality tubes, which should give you years of trouble free service, howeve...

  • Page 13: Cub

    Laney page 13/ 16 cub 2 preamp tubes ecc83 output tubes el84 • to change a tube; switch off the unit and unplug from the mains supply. Wait for the tubes to cool down. Lay amplifier down on its front face and remove the protective grille held in place with four screws. You should now be able to acce...

  • Page 14: Cub

    Page 14 / 16 laney gs412ia rock alone... ...Or with the neighbours!! Sample set up cub 2 fx controller input output (to avoid poor sound only use good quality guitar cables). Cub 2 laney lzb1 2 3 4 maximum power consumption 50 watts 50/60hz supply voltage:.

  • Page 15: Cub

    Cub 2 laney page 15 / 16 your cub-12 features a tilting mechanism to allow use in either the upright or tilted back position. Employez cette caractéristique de conception avec prudence, en raison de la facilité avec laquelle l'amplificateur peut être déplacé entre directement et en arrière inclinées...

  • Page 16

    Power to the music laney in the interest of continued product development, laney reserves the right to amend product specification without prior notification. W w w . L a n e y . C o . U k l a n e y a m p l i f i c a t i o n.