Laney Cub 212R User Manual - page 7
LZB1 2 3 4
7
Rear Panel Controls
12
15
16
17
13
14
12
13
14
15
EXTENSION CABINET: Use to connect an 8-16 ohm extension cabinet. Please note mismatched impedance will
reduce the amplifiers performance and in some cases may cause damage to your amplifier. Try your CUB12R into a Laney
extension cabinet - you will be amazed.
EFFECTS LOOP: SEND/LINE OUT: Connect the input of your external effect to this socket. This is an insert type
control, therefore all of the signal leaves the amplifier via the `Send’ socket to be processed. This socket can also be used
as a Line Level Out. (-10dBV Nominal)
EFFECTS LOOP: RETURN: Connect the output from your external effects to this socket. The effects loop allows you
to connect external effects such as tremolo, chorus and delay to your amplifier. (-10dBV Nominal)
FOOTSWITCH SOCKET: Provided for the connection of a Laney FS1 footswitch (optional) .This allows you to
remotely switch the built in Digital Reverb On/Off.
POWER INLET SOCKET: Connect to your power source. Make sure the specified voltage is correct for your
country!
POWER FUSE: This drawer contains the main safety fuse for the unit. USE ONLY THE CORRECT SIZE AND RATING
OF FUSE AS SPECIFIED ON THE PANEL. If a fuse blows or fails and a replacement of the same size and rating is installed
and it in-turn blows, the amplifier has suffered a malfunction internally and needs immediate service from a qualified
technician. DO NOT TRY USING A FUSE OF HIGHER RATING. This may cause serious, irreparable damage to the
amplifier and presents a serious fire hazard. The mains fuse ratings are detailed in the specification section at the rear of
this manual. (Always switch off and disconnect the power cord when not in use).
SERIAL NO: Displays the model details and serial number of the unit
17
16