Laney CUB HEAD Operating Instructions Manual

Summary of CUB HEAD

  • Page 1

    Opera ting instr uctions - 1.2 cub head.

  • Page 2: Cub Head

    Warning: when using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions safe. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do no...

  • Page 3: Cub Head

    Attention: l’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce manuel. 4. Suivez ces instructions. 5. N’utilisez pas cette unité pr...

  • Page 4: Cub Head

    Achtung: beim einsatz von elektrogeräten müssen u.A. Grundlegende vorsichtsmaßnahmen befolgt werden: 1. Lesen sie sich diese anweisungen durch. 2. Bewahren sie diese anweisungen auf. 3. Beachten sie alle warnungen. 4. Befolgen sie alle anweisungen. 5. Setzen sie dieses gerät nicht in der nähe von wa...

  • Page 5: Cub Head

    Cuidado: cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: 1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6. Limpiar solamente con una...

  • Page 6: Cub Head

    Before switching on 6 after unpacking your amplifier check that it is factory fitted with a three pin 'grounded' (or earthed) plug. Before plugging into the power supply ensure you are connecting to a grounded earth outlet. If you should wish to change the factory fitted plug yourself, ensure that t...

  • Page 7: Cub Head

    Specifications 7 nominal supply voltage ~100v, ~115v, ~220v, ~230v, 50/60hz power consumption 50w output power rating 15w input impedance 1mohm size (h*w*d) 248*435*235 unit weight operating voltage factory set loudspeaker outputs 1x 8 ohm extension speaker socket features class a/b push/pull circui...

  • Page 8: Cub Head

    Dear player, thank you very much for purchasing your new laney product and becoming part of the worldwide laney family. Each and every laney unit is designed and built with the utmost attention to care and detail, so i trust yours will give you many years of enjoyment. Laney products have a heritage...

  • Page 9: Cub Head

    The cub head is a single channel, master volume type tube amplifier, featuring 3 x ecc83/12ax7 preamp tubes and 2 x el84 output tubes. Its 15w class a/b push/pull circuitry pumps out classic tube tones to the cabinet of your choice. The chocolate brown fascia panel features vintage style, simplicity...

  • Page 10: Cub Head

    Input volume tone reverb bass middle treble gain 15w 6 5 4 3 2 1 7 power switch: main power switch for the unit. Tube amplifiers take between 30 seconds and 2 minutes to warm up and be ready to play after switching on, this is normal. The tone control works in a similar fashion to the tone control y...

  • Page 11: Cub Head

    12 10 11 15 13 14 11 12 13 17 15w input: plugging into this input uses the amplifier in full power mode. Input: plugging in to this input switches the output power stage down to around 1w. (use this feature for recording or bedroom playing). (always switch off and disconnect the power cord when not ...

  • Page 12: Cub Head

    Tube amplifier survival tips • tube amplifiers; generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect due to the fragile glass tubes themselves. The uses top quality tubes, which should give you years of trouble free service, however like...

  • Page 13: Cub Head

    Preamp tubes ecc83 output tubes el84 • to change a tube: • servicing: the user should not attempt to service these products. Refer all servicing to qualified service personnel. Switch off the unit and unplug from the mains supply. Wait for the tubes to cool down. Lay amplifier down on its front face...

  • Page 14: Cub Head

    14 sample set ups (to avoid poor sound only use good quality guitar cables). Cub head (bedroom playing or recording) 15w input (full power mode) cub cab can be be used either way up!.

  • Page 15: Cub Head

    Gs412ia fx controller 15 cub head lzb1 2 3 4 input output guitar output sockets for 8 or 16 ohm cabinets (use only one output at a time).

  • Page 16

    In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal household waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the weee (waste electrical and electronic equipment) ...