Laney IronHeart IRT120H Instructions Manual

Summary of IronHeart IRT120H

  • Page 1

    Irt120h irt60h.

  • Page 2

    Warning: when using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions safe. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do no...

  • Page 3

    Attention: l’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce manuel. 4. Suivez ces instructions. 5. N’utilisez pas cette unité pr...

  • Page 4

    Achtung: beim einsatz von elektrogeräten müssen u.A. Grundlegende vorsichtsmaßnahmen befolgt werden: 1. Lesen sie sich diese anweisungen durch. 2. Bewahren sie diese anweisungen auf. 3. Beachten sie alle warnungen. 4. Befolgen sie alle anweisungen. 5. Setzen sie dieses gerät nicht in der nähe von wa...

  • Page 5

    Cuidado: cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: 1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6. Limpiar solamente con una...

  • Page 7

    Irt120h irt60h supply voltage (factory preset) ~100v, ~120v, ~220v, ~230v, ~240v 50/60hz mains fuse ~100v/~120v: t5a l 250v ~220v/~230v/~240v: t2a l 250v ht fuse t1a l t500ma l power consumption 300 watts 200 watts output power rating 120 watts 60 watts input impedance 1mohm loudspeaker outputs 4, 8...

  • Page 9

    Forged deep within the black country - the metal beating industrial heartland of the uk - where the sound of metal guitar was born, comes the ironheart. With molten metal flowing through its circuits, ironheart continues the legacy passed on by previous laney amps such as klipp and aor, and hits you...

  • Page 10

    (pull deep) (pull shift) (pull shift) front panel controls 1. Input 1/4" mono jack socket. Connect your guitar here. Use only a good quality instrument cable. 2. Pre-boost switch switches the input boost circuit on or off. The pre-boost circuit increases the input signal to the preamp tubes, just li...

  • Page 11

    Front panel controls 9. Channel switch switches between the lead and clean/rhythm channels. 10. Channel leds indicates which channel is currently selected by the channel switch (9). 11. Clean/rhythm switch this switch activates the clean mode on the rhythm channel. When operated, the clean volume (1...

  • Page 12

    Rear panel controls l z b 1 2 3 4 1. Mains inlet socket connect to your power source. Make sure the voltage indicated on the rear panel is correct for your country! 2. Mains fuse this drawer contains the main safety fuse for the unit. The fuse protects the amplifier from damage in the event of fault...

  • Page 13

    5. Fx return 1/4" mono jack socket for the connection of the output of an external fx unit. This can also be used as a slave in for the power amp. As the fx loop is an insert type, this will mute the preamp signal. 6. Fx loop switch selects the fx loop mode of operation: ! Bypass - removes the fx lo...

  • Page 14

    Quick start settings (pull deep) (pull shift) (pull shift) clean (pull deep) (pull shift) (pull shift) rock (pull deep) (pull shift) set to preference rhythm lead metal rhythm lead (pull shift) detuned metal rhythm lead (pull shift).

  • Page 15

    User settings (pull deep) (pull shift) (pull shift) (pull deep) (pull shift) (pull shift) (pull deep) (pull shift) (pull shift) (pull deep) (pull shift) (pull shift).

  • Page 16

    Tube amp tips tube amplifiers generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect due to the fragile glass tubes. The ironheart heads use four 12ax7 preamp tubes, and two or four 6l6 output tubes (depending on the model) which should gi...

  • Page 17

    Block diagram input lead gain external loudspeaker 4-16 ohms fx return line out fx send 16ohms bypass 0 dbu -10dbu reverb reverb level clean/rhythm rhythm gain clean volume clean/rhythm eq bass mid treble deep mid shift treble shift lead eq bass mid treble deep mid shift treble shift lead volume rhy...

  • Page 18

    Sample setup l z b 1 2 3 4 fx unit irt412 fs4-irt guitar.

  • Page 19

    L z b 1 2 3 4 irt412 fs4-irt guitar irt412 fx unit.

  • Page 20

    1.2.