Summary of IRT-Studio IronHeart
Page 2
Warning: when using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions safe. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do no...
Page 3
Attention: l’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce manuel. 4. Suivez ces instructions. 5. N’utilisez pas cette unité pr...
Page 4
Achtung: beim einsatz von elektrogeräten müssen u.A. Grundlegende vorsichtsmaßnahmen befolgt werden: 1. Lesen sie sich diese anweisungen durch. 2. Bewahren sie diese anweisungen auf. 3. Beachten sie alle warnungen. 4. Befolgen sie alle anweisungen. 5. Setzen sie dieses gerät nicht in der nähe von wa...
Page 5
Cuidado: cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: 1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6. Limpiar solamente con una...
Page 7
Fcc compliancy statement this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference 2) this device must accept any interference received, that may cause undesired operation. Warning: changes or modificat...
Page 9
Forged deep within the black country - the metal beating industrial heartland of the uk - where the sound of metal guitar was born, comes the ironheart. With molten metal flowing through its circuits, ironheart continues the legacy passed on by previous laney amps such as klipp and aor, and hits you...
Page 10
Front panel controls 13 7 14 11 10 15 16 12 15w input: mono jack socket. Connect your guitar here to get full volume output. Use only high quality guitar cable. Mono jack socket. Connecting your guitar here switches the output stage to under 1w. This allows you to drive the output stage hard at bedr...
Page 11
Front panel controls lead volume: controls the lead channel volume. Experiment with different combinations of the drive and volume controls to achieve different sounds. Reducing the drive while increasing the volume will result in a warm, open, overdriven sound as the power amp is driven harder, whi...
Page 12
Rear panel controls mains inlet socket - mains fuse: make sure the voltage indicated on the rear panel is correct for your country! This drawer contains the main safety fuse for the unit. The fuse protects the amplifier from damage in the event of fault by disconnecting the mains power supply. Ht fu...
Page 13
Rear panel controls usb: record replay connector, (dry on left channel, processed on right channel). Usb2.0 is compatible with windows xp ® operating system , ® operating system & ® operating system . Also compatible with ma c ® & windows 7 windows 8 ipad ® ® ® via lightning-usb camera adaptor cable...
Page 14
Specifications 14 ~100v, ~120v, ~2 20v, ~230v, ~2 40v 50/60hz ~100v>~120v t500ma l ~220v>~240v t250ma l t100ma l 60w 15w 3 - clean, rhythm & lead high and low powe r input sockets pre-boost input control 3 x 12ax7/ecc83 preamp tubes 2 x el84 output tubes emulate d di & phones with level control 3.5m...
Page 15
Quick start settings rock metal clean detuned metal rhythm lead rhythm lead rhythm lead set to preference.
Page 16
Tube amp tips tube amplifiers generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect due to the fragile glass tubes. The irt-studio uses three 12ax7 preamp tubes, and 2 el84 output tubes which should give you years of trouble free service,...
Page 17
17 l z b 1 2 3 4 sample setup fx unit mixer desk or powered cab irt-212 fs4-irt ipad or ipad mini ®.
Page 18
Signal path block diagram return send tube pre-amplifier fx loop mix mix reverb load fx aux/cd/mp3 input xlr balanced di to pa/desk speaker usb 2.0 port external cable dry signal gain 12db - 0 - +12db user external fx processors guitar input re-amp out emulation switch monitor switch unbalanced ster...
Page 19
Usb interface for pc, mac & ipad usb interface options: ■ usb2.0 bidirectional to pc/mac/ipad etc. ■ record output of amplifier with or without a speaker load connected ■ simultaneously record dry guitar signal for later processing or re-amping. ■ re-amp guitar track changing the settings as require...
Page 20
20 usb interface for pc, mac & ipad irt studio usb recording: connect your usb recording device (pc/mac or ipad) via an appropriate usb cable. Your amplifier will send two audio tracks to your recording device: (1) on the left channel the direct unaffected guitar signal. (2) on the right channel the...
Page 21
21 usb interface for pc, mac & ipad irt studio usb “re-amping”: connect usb cable as for recording. Then connect a good quality screened guitar cable from the rear panel “re-amp” output jack and loop round the front panel to guitar input jack. Start your record device. The monitored track will be se...
Page 22
22 usb optional speaker load ipad/mac/pc recording device irt-studio fx fx usb optional speaker load ipad/mac/pc recording device irt-studio proceed as for normal “re-amping” except in this case insert your fx box/s into the guitar lead from the re- amp out jack to the guitar amplifier input. The re...
Page 23
23 rack mounting ventilation: ensure the amplifier is well ventilated and that the ventilation slots in the top, bottom & sides are not obstructed in any way. Avoid dropping anything in through the vents especially liquids of any kind. If this should happen turn off the product and disconnect from t...
Page 24
.L.