Laney L20T-410 Operating Instructions Manual - page 15
Laney
OPERATING INSTRUCTIONS
2
T
4
L
0
-
10
This product conforms to the requirements of the following European Regulations, Directives & Rules:-
CE Mark (93/68/EEC), Low Voltage (72/23/EEC), EMC (93/68/EEC),
RoHS (EU2002/95/EC), WEEE (EU2002/96/EC)
Page 15 /16
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal
household waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the WEEE
(Waste Electrical and Electronic Equipment) directive applicable in your country.
Pure Single Ended Class A Valve tone.
Gold plated PCB's and Jacks, Hi and Low Gain Inputs.
Sealed gold contact relays used in all signal switching for minimum effect to your sound.
Oversized power supplies and output transformers for that big powerful sound and long term reliability.
The best available specially selected tubes throughout, (4*EL84 Power Tubes, 3*ECC83/12AX7 Preamp Tubes TAD Selected).
The renowned "type 4" large spring line for that classic guitar reverb sound.
Birch plywood cabinet construction for optimum sound quality and road worthinness.
Unique Tilt Mechanism.
SPECIAL FEATURES
SPECIFICATIONS
Supply Voltage: Factory Pre-set Option
~100V, ~120V, ~220V, ~230V, ~240V 50/60Hz
Mains Fuse:
(~220V>240V = T630mA L 250V)
(~100V>120V = T1.6A L 250V)
HT Fuse:
T315mA L
Power Consumption:
50W
Output Power Rating:
20W
FX Loop:
Side Chain type, nominal 750mV level.
Loudspeaker:
4 x Jensen P10R 8 Ohms
Loudspeaker outputs:
4/8/16 Ohms sockets
EQ:
Passive Bass, Middle and Treble
Tone Boost & cut (Active on top end of signal)
Bright Switch
Input Impedance:
1MOhm
Size:
636*559*285 (H*W*D)
Unit Weight:
30.5 Kg (Shipping Weight 32.0 Kg)