Laney Linebacker LR35 Operating Instructions Manual

Summary of Linebacker LR35

  • Page 2

    Warning: when using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions safe. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do no...

  • Page 3

    Attention: l’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce manuel. 4. Suivez ces instructions. 5. N’utilisez pas cette unité pr...

  • Page 4

    Achtung: beim einsatz von elektrogeräten müssen u.A. Grundlegende vorsichtsmaßnahmen befolgt werden: 1. Lesen sie sich diese anweisungen durch. 2. Bewahren sie diese anweisungen auf. 3. Beachten sie alle warnungen. 4. Befolgen sie alle anweisungen. 5. Setzen sie dieses gerät nicht in der nähe von wa...

  • Page 5

    Cuidado: cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: 1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6. Limpiar solamente con una...

  • Page 7

    In the interest of continued development, laney reserves the right to amend product specification without prior notification. Nominal supply voltage ~100v, ~115v, ~220v, ~230v, 50/60hz factory option mains fuse (~100, ~110>~120v = t500ma l 250v) (~220v, ~230v, ~240v = t250ma l 250v) power consumptio...

  • Page 9

    The linebacker series is a state of the art, processor-based design, enabling a wide range of different sounds to be created from your guitar. The 35w lr35 model, with features such as; a 10" custom driver, 2 channels, 2 x 11 built in amp models and range of "must have" effects like; chorus, phase, ...

  • Page 11

    N15039 l z b 1 2 3 4 always switch off & disconnect the power cord when not in use. Spare power fuse included in the pull out tray..

  • Page 12

    Quick start section:-controls: get up & running quickly power inlet socket: connect to your power source. Power: this is the main power on off switch. Input jack: connect your guitar here. Use only good quality cables to avoid poor sound quality. Channel 1 & 2 amp model selection: choose from the va...

  • Page 13

    Headphone/record out: a rear panel 6.35” stereo jack is provided for headphone use. Footswitches: the rear panel has jack connectors for two footswitches. Channel: use to switch between channels. Effects: use to switch: (1) mod fx on/off & (2) del fx on/off.

  • Page 14

    Tuner operation: by pressing the tuner button the amplifier will mute and the tuner function will be activated. The round led above the tuner button will flash to indicate tuner operation. The amp selector on channel 2 should then be used to select each string in turn to be tuned. These are e,b,g,d,...

  • Page 15

    Power: this is the main power on/off switch. After switch on all of the led’s on the fascia light up momentarily, after a couple of seconds the led’s indicate the previous settings used: i.E. If the amp was last used on channel 1 with reverb, the channel 1 & del fx led’s will be lit. All other contr...

  • Page 16

    Channel 1 & 2 settings: the control levels set on ch1 and ch2 are not lost when switching between channels. For example, ch1 may be set up as a clean sound with chorus & reverb applied & both eq settings at 5. If you now switch to ch2, change to an overdrive sound and alter the eq & fx controls, whe...

  • Page 17

    Del fx: activate by pressing the on button. The first section of the rotary control adjusts the length of delay applied to the signal, the led will flash according to the delay time. The second half of the control adjusts the length of reverb applied to the signal from room to cathedral. These setti...

  • Page 18: Factory Reset:

    Serial no: displays the model and serial number of the unit. Power inlet socket: connect to your power source. Make sure the specified voltage is correct for your country! Power fuse: this drawer contains the main safety fuse for the unit and also a spare in the pull out tray. The fuse protects the ...

  • Page 19

    Linebacker sounds tone description amp modelled crystal pure & clean clean channel of an lc amp - bright and full crystal + clean with compression clean channel of an lc amp - bright and full + a clean boost pedal to give more low end vc clean & warm a vc combo set clean vc+ 1 x 12" combo semi disto...

  • Page 20

    N15039 l z b 1 2 3 4 headphones or mixer desk mp3 mp3.

  • Page 23

    Notes.

  • Page 24

    Issue: 1.2.