All tube heritage amplifier ‘class a’ l20h opera ting instr uctions - 1.3 l a n e y a m p l i f i c a t i o n w w w. L a n e y. C o . U k.
Save these instructions important safety instructions warning: when using electric products, basic cautions should always be followed, including the following. 1. Read all safety and operating instructions before using this product 2. The product should be powered by a three pin `grounded (or earthe...
L20h caution: caution: warning: intended to alert the user to the presence of uninsulated ‘dangerous voltage’ within the products enclosure that may be sufficient to constitute a risk of electrical shock to persons. Intended to alert the user of the presence of important operating and maintenance (s...
Before switching on after unpacking your amplifier check that it is factory fitted with a three pin 'grounded' (or earthed) plug. Before plugging into the power supply ensure you are connecting to a grounded earth outlet. If you should wish to change the factory fitted plug yourself, ensure that the...
Introduction the dark art: in an age where guitar players have developed an unhealthy fascination with pre-amp distortion, the fabled sound of a tube power amp being pushed hard has almost passed into history. Until now that is! The l20h’s hand wired 20w class a single ended output stage oozes class...
Hi input: lo input: ‘ . Clean vol: bright: drive: ‘hi’ stands for high gain. This input is designed for the connection of low output level guitars making it well suited for guitars with single coiled or low gain humbucker type pickups. Use of high gain pickups in this input may drive the preamp too ...
Ability to drive the output stage at higher drive volume settings. Setting a high level on the drive control and a low setting on the drive volume will give you a punchy hard rock lead tone, with the ability to again drive the output tubes at higher drive volume settings. Having set the drive and dr...
Power: main power switch for unit. Power inlet socket. Connect to your power source. Make sure the specified voltage is correct for your country! Power fuse: this drawer contains the main safety fuse for the unit. The fuse protects the ac power to the amplifier. Use only the correct size and rating ...
Operating instructions effects loop return: connect the output from your external effects to this socket. The effects loop allows you to connect external effects such as tremolos, chorus and delays to your amplifier. A portion of the signal leaves the amplifier via the `send’ socket and comes back f...
Operating instructions quick start settings - suggestions only, experiment! L20h.
Operating instructions l20h user settings - store your own cool sounds.
L20h operating instructions tube amplifier survival tips " take care when moving the amplifier. Tubes are fragile glass components, they can easily be damaged if thrown in and out of transit vans, " make sure the impedance of your cabinets matches the setting on your amplifier. Improper impedance ma...
Operating instructions l20h connections with fx l20h with extension cabinets input output fx controller l20h 8 ohms 4 ohms.
Operating instructions operating instructions general notes amplifier connection: in order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your equipment. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects proc...
Operating instructions l20h this product conforms to the requirements of the following european regulations, directives & rules:- ce mark (93/68/eec), low voltage (72/23/eec), emc (93/68/eec), rohs (eu2002/95/ec), weee (eu2002/96/ec) in order to reduce environmental damage, at the end of its useful ...
In the interest of continued product development, laney reserves the right to amend product specification without prior notification. Power to the music l a n e y a m p l i f i c a t i o n w w w. L a n e y. C o . U k.
