Laney RB1 Operating Instructions Manual

Other manuals for RB1: User Manual
Manual is about: Richer Bass

Summary of RB1

  • Page 1

    Richter bass.

  • Page 2

    Warning: when using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions safe. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do no...

  • Page 3

    Attention: l’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce manuel. 4. Suivez ces instructions. 5. N’utilisez pas cette unité pr...

  • Page 4

    Achtung: beim einsatz von elektrogeräten müssen u.A. Grundlegende vorsichtsmaßnahmen befolgt werden: 1. Lesen sie sich diese anweisungen durch. 2. Bewahren sie diese anweisungen auf. 3. Beachten sie alle warnungen. 4. Befolgen sie alle anweisungen. 5. Setzen sie dieses gerät nicht in der nähe von wa...

  • Page 5

    Cuidado: cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: 1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6. Limpiar solamente con una...

  • Page 6

    6 after unpacking your amplifier check that it is factory fitted with a three pin 'grounded' (or earthed) plug. Before plugging into the power supply ensure you are connecting to a grounded earth outlet. If you should wish to change the factory fitted plug yourself, ensure that the wiring convention...

  • Page 7

    7 in the interest of continued development, laney reserves the right to amend product specification without prior notification. Specifications block diagram internal loudspeaker gain input volume active on eq section compressor section use this design feature with caution, due to the ease with which...

  • Page 8

    8.

  • Page 9

    The laney rb1 - the 'baby' of the richter line up probably stands out more than the rest simply due to its ability to kick out an enormous amount of sound from such a portable cabinet. Its 8" custom designed speaker seriously delivers and combined with a simple yet versatile front end with switchabl...

  • Page 10

    10 9 8 7 6 5 4 3 2 1 input socket for connection of bass guitars.The socket will accommodate high or low output basses, either active or passive. This control is used to set the level of gain present in the pre-amp. The higher the level of gain, the more the signal will clip producing distortion. Th...

  • Page 11: Always Switch Off

    Sample system always switch off and disconnect power cord when not in use 2 3 3 1 2 1 power inlet socket. Connect to your power source. Check that the voltage supplied is correct for you country. Mains power switch. Serial number and model of your unit. Power 0 1 in order to reduce environmental dam...

  • Page 12

    Operating instructions - issue: 1.