Laney RB2 Instructions Manual

Other manuals for RB2: User Manual
Manual is about: RB2; RB3

Summary of RB2

  • Page 1

    Richter bass.

  • Page 2

    Warning: when using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions safe. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do no...

  • Page 3

    Attention: l’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce manuel. 4. Suivez ces instructions. 5. N’utilisez pas cette unité pr...

  • Page 4

    Achtung: beim einsatz von elektrogeräten müssen u.A. Grundlegende vorsichtsmaßnahmen befolgt werden: 1. Lesen sie sich diese anweisungen durch. 2. Bewahren sie diese anweisungen auf. 3. Beachten sie alle warnungen. 4. Befolgen sie alle anweisungen. 5. Setzen sie dieses gerät nicht in der nähe von wa...

  • Page 5

    Cuidado: cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: 1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6. Limpiar solamente con una...

  • Page 6

    6 after unpacking your amplifier check that it is factory fitted with a three pin 'grounded' (or earthed) plug. Before plugging into the power supply ensure you are connecting to a grounded earth outlet. If you should wish to change the factory fitted plug yourself, ensure that the wiring convention...

  • Page 7: Rb2

    7 in order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal household waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the weee (waste electrical and electronic equipment...

  • Page 8

    8.

  • Page 9

    9 the rb2 very portable but packs a powerful 30w rms output package. It also features a flexible parametric mid control, aux in and di for versatile connection options. The 65 watt rb3 is the ideal amp for those smaller gigs. Its twin side handles, rugged construction and kick proof metal grille ens...

  • Page 10

    10 front panel controls 3 2 1 normal and high inputs are provided for connection of bass guitars. High output basses, either active or passive should be connected via the high socket. Low output basses should be connected using the normal input. High output basses may also be placed in the normal in...

  • Page 11

    4 11 12 13 14 10 9 8 6 7 5 always switch off and disconnect power cord when not in use controls the boost and cut of the low-frequency response of the pre-amplifier. Selects the mid-frequencies (200hz to 2khz) to be cut or boosted in conjunction with the paramid level control to access low mid-frequ...

  • Page 12

    12 rear panel controls 4 3 2 1 1 3 2 2 4 voltage selection switch: this is factory set to the correct voltage for the region the product is supplied to. If necessary it can be reset by removing the mains lead and then loosening (but not removing) the screws securing the cover. The cover can then be ...

  • Page 13

    13 block diagrams eq section eq section this loop is a series type so all your signal will go through your fx unit. Gain gain headphones (3.5) headphones (3.5) volume volume fx loop send return d.I. D.I. Inputs inputs normal normal hi hi pad pad loudspeaker loudspeaker general notes amplifier connec...

  • Page 14

    14 high normal 7 1 9 3 10 4 6 0 5 8 2 volume 2 4 4 2 5 1 1 5 0 3 3 - + bass 2 4 4 2 5 1 1 5 0 3 3 - + 2 4 4 2 5 1 1 5 0 3 3 - + treble aux in phones 5 gain comp active 7 1 9 3 10 4 6 0 8 2 2k 200 850 frequency level para-mid richter bass equalisation power d.I. Out on sample system systems & setting...

  • Page 15

    High normal volume bass treble aux in d.I fx send fx return gain active frequency level para-mid 7 1 9 3 10 4 6 0 5 8 2 2 4 4 2 5 1 1 5 0 3 3 - + 2 4 4 2 5 1 1 5 0 3 3 - + 2 4 4 2 5 1 1 5 0 3 3 - + comp 5 7 1 9 3 10 4 6 0 8 2 2k 200 850 power richter bass equalisation phones on use this design featu...

  • Page 16

    Operating instructions - issue: 1.