Laney Richter Bass RB7 User Manual - page 8
3
5
1
Page 8 /12
Page 9 /12
2
3
4
5
Power inlet socket. Connect to your power source. Make sure the specified voltage is correct for your country!
This drawer contains the main safety fuse for the unit.
USE ONLY THE CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL.
The mains fuse ratings are detailed in the specs section at the rear of this manual.
Serial Number and model of your unit.
This socket(s) should be used to connect an extension-cabinet. The impedance of the extension-cabinet must not be less
than 8 Ohms. Connecting cabinets that have a lower impedance than 8 Ohms will result in the amplifier overheating.
Continual use in this manner may cause permanent damage. Connecting a cabinet with an impedance of greater than 8
Ohms will cause no damage to the amplifier but will result in a reduced output level. (When using an extension cabinet the
internal speaker remains connected)
Socket for connecting external tuner. This output taken before any EQ so the Volume control may be turned down for silent
tuning.
Send and return sockets are provided for connecting external effects-units. You can also use the Send socket as a line out if you
wish.
REAR PANEL CONTROLS
OTHER FEATURES
8 Ohms
Link
Model
RB115
Power Rating
300W Program
Model
RB115
Power Rating
300W Program
Serial Number:
Serial Number:
Input
Laney
Power To The Music
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
8 Ohms
Link
Model
RB115
Power Rating
300W Program
Model
RB115
Power Rating
300W Program
Serial Number:
Serial Number:
Input
Laney
Power To The Music
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
SAMPLE
BLOCK DIAGRAM
RB115
Laney
OPERATING INSTRUCTIONS
Laney
OPERATING INSTRUCTIONS
INTERNAL
LOUDSPEAKERS
D.I. OUT
TUNER OUT
GAIN
INPUT
VOLUME
FX LOOP
SEND
RETURN
OUTPUT
ON
ACTIVE
LIMITER
SECTION
EQ SECTION
COMPRESSOR
SECTION
ACTIVE
POWER
AMP
This loop is a series type so all
your signal will go through your
FX unit.
1
4
Tuner Input
In
p
u
t
O
u
tp
u
t
SAMPLE SYSTEM
2
6
6
NORMAL
HIGH
PAD
Your RB7 features a kick style design to enable you to use
it as a stage monitor, or a conventional straight combo.