1. DL manuals
  2. Lang
  3. Griddle
  4. 124S-M
  5. Installation, Operation And Maintenance Instructions

Lang 124S-M Installation, Operation And Maintenance Instructions - Equipment Description

Manual is about: Electric/Seletronic Griddle-Marine

Summary of 124S-M

  • Page 1

    Star manufacturing international 10 sunnen drive st. Louis, mo.63143-3800 part number: 2m-w354 ph: 314-781-2777 fax: 314-781-2714 rev.B www.Star-mfg.Com may 31, 2007 installation, operation, and maintenance instructions electric/seletronic griddle-marine models : 124s-m 136s-m 148s-m 160s-m 172s-m.

  • Page 2: Notice

    Notice this supplement is for marine installed equipment only. This equipment is approved for installation only on vessels greater than 65 feet in length, in accordance with uscg regulations in title 46 cfr 110-113. Any wiring used in the installation of this appliance must be stranded copper..

  • Page 3: Safety

    3 safety caution: the griddle is extremely heavy. For safe handling, installer should obtain help as needed, or employ appropriate materials handling equipment (such as a forklift, dolly, or pallet jack) to remove the unit from the skid and move it to the place of installation. Caution: any stand, c...

  • Page 4

    4 warning: keep water and solutions out of controls. Never spray or hose control console, electrical connections, etc. Caution: most cleaners are harmful to the skin, eyes, mucous membranes and clothing. Precautions should be taken to wear rubber gloves, goggles or face shield and protective clothin...

  • Page 5

    5 table of contents 1. Notice...................................................................... 2 2. Precautions/information.......................................... 3 3. Table of contents................................................... 5 4. Equipment description................................

  • Page 6: Equipment Description

    6 equipment description exterior construction the griddle dimensions are 17". (43.18cm) high, 30" (76.20cm) deep, and width depends on the actual model number. The sides, bottom, and rear wall are constructed of double wall stainless steel, which allows closer installation to combustible surfaces. T...

  • Page 7: Unpacking

    7 unpacking receiving the griddle upon receipt, check for freight damage, both visible and concealed. Visible damage should be noted on the freight bill at the time of delivery and signed by the carrier's agent. Concealed loss or damage means loss or damage which does not become apparent until the m...

  • Page 8: Installation

    8 installation danger this appliance must be grounded at the terminal provided. Failure to ground the appliance could result in electrocution and death. Warning installation of the unit must be done by personnel qualified to work with electricity. Improper installation can cause injury to personnel ...

  • Page 9: Installation

    9 installation technical data nominal amps per line three phase single phase 208 volt 240 volt 480 volt model number total kw l1 l2 l3 l1 l2 l3 l1 l2 l3 208v 240v 24” 12.0 50.0 28.8 28.8 43.3 25.0 25.0 21.7 12.5 12.5 57.7 50.0 36” 18.0 50.0 50.0 50.0 43.3 43.3 43.3 21.7 21.7 21.7 86.5 75.0 48” 24.0 ...

  • Page 10: Initial Start Up

    10 initial start up notice during the first few hours of operation you may notice a small amount of smoke coming from the griddle surface, and a faint odor from the smoke. This is normal for a new unit and will disappear after the first few hours of use. Caution always keep the area near the applian...

  • Page 11: Operation

    11 operation setting the temperature if different temperature settings across the same griddle are to be used, select one side of the griddle and run that at the lowest temperature. Adjoining sections should be set at progressively higher temperatures. Do not try to run the end sections hot and the ...

  • Page 12: Cleaning

    12 cleaning warning keep water and solutions out of controls. Never spray or hose control console, electrical connections, etc. Caution most cleaners are harmful to the skin, eyes, mucous membranes and clothing. Precautions should be taken to wear rubber gloves, goggles or face shield and protective...

  • Page 13: Troubleshooting

    13 troubleshooting notice service on this or any other lang manufacturing appliance must be performed by qualified personnel only. Consult your authorized service agent directory or call the factory at 1-800-807-9054, or visit our website at www.Star-mfg.Com for the service agent nearest you. Warnin...

  • Page 14: Troubleshooting Cont’D

    14 troubleshooting cont’d testing possible cause test product is cooked too long • no test available, operational condition failed probe • check probe for proper resistance failed circuit board • confirm that circuit board is getting correct voltage and putting out correct voltage* failed transforme...

  • Page 15: Parts List

    15 parts list may 31, 2007, rev. B 124s-480vm selectronic marine griddle part no. Description qty application 2a-72500-05 leg 4 w/bolt down adj 4 124s-480vm 2e-30303-06 swt tog on-on dpdt blk 3 124s-480vm 2e-30304-22 swtcb175-450ofw/41100-13 2 124s-480vm 2e-30500-02 trm strp 4 pole 30a 600v 1 124s-4...

  • Page 16: Parts List

    16 parts list may 31, 2007, rev. B 148s-480vm selectronic marine griddle part no. Description qty application 2a-72500-05 leg 4 w/bolt down adj 4 148s-480vm 2e-30303-06 swt tog on-on dpdt blk 5 148s-480vm 2e-30304-22 swtcb175-450ofw/41100-13 4 148s-480vm 2e-30500-07 trm block 3plelrge 125amp 1 148s-...

  • Page 17: Parts List

    17 parts list may 31, 2007, rev. B 172s-440vm selectronic marine griddle part no. Description qty application 2a-72500-05 leg 4 w/bolt down adj 8 172s-440vm 2e-30500-03 trm strp 6 pole 30a 300v 2 172s-440vm 2e-30500-07 trm block 3plelrge 125amp 2 172s-440vm 2e-30501-05 trm strp 6 pole w/2push 2 172s...

  • Page 18: Iring Diagram

    18 w iring diagram wiri.

  • Page 20

    Star manufacturing 10 sunnen drive, st. Louis, mo 63143 u.S.A. (800) 807-9054 (314) 781-2777 parts & service (800) 807-9054 www.Star-mfg.Com.