- DL manuals
- Lang
- Griddle
- 136SDI
- Installation And Operation Instructions Manual
Lang 136SDI Installation And Operation Instructions Manual
Summary of 136SDI
Page 1
Il1388 selectronic drop-in electric griddle 36sdi, 48sdi, 60sdi installation and operation instructions 2m-w355 rev. C 11/10/08 60sdi.
Page 2
These symbols are intended to alert the user to the presence of important operating and maintenance instructions in the manual accompanying the appliance. For your saftey do not store or use gasoline or other flammable vapors and liquids in the vicintiy of this or any other appliance. Post in promin...
Page 3
3 table of contents specifications 4 equipment description 5 unpacking 6 installation prepare the cabinet 7 install griddle into the cabinet 8 electrical connection 8 initial start-up pre-power on 9 power on 9 seasoning cooking surface 9 operation general 0 operations 0 suggested times and temperatu...
Page 4
4 28. 5" 723mm 11 .1" /281mm 7.6" /194mm 2.5" /64mm 2.8" /70mm min. 6.5"/165 mm 11 .1" /281mm 74. 4" /1890mm 62. 4" /1586mm 50. 4" /1281mm 38. 4" /976mm 26. 4" /672mm 26.8 " 679 mm width varies by mod e l width & pos ition vary by model 28.5 "/ 723mm il1572 equipment specifications model top-rough o...
Page 5
5 equipment description electric drop-in griddle the griddle dimensions are 26” (66cm) deep, 5 3/8” (13.65cm) high, and width is dependent on model number. The griddle surface is constructed of 1” thick highly polished steel to ensure even heat throughout the griddle. This reduces hot and cold spots...
Page 6
6 unpacking receiving the griddle upon receipt, check for freight damage, both visible and concealed. Visible damage should be noted on the freight bill at the time of delivery and signed by the carrier’s agent. Concealed loss or damage means loss or damage, which does not become apparent until the ...
Page 7
7 installation prepare the cabinet cabinet base must have cross air ventilation. It does not matter if it is on the ends or sides. If vents are not installed, the controls may overheat rendering the griddle useless. For best results, provide a knockout for the control panel a minimum of 4½”- from th...
Page 8
8 installation cont. Install the griddle into the cabinet turn the griddle over, taking care not to kink or pinch any sensor wires. Set the griddle on the table that it is to be installed in (leaving a hole big enough to slip the control panel through). Insert the control panel through the hole and ...
Page 9
9 initial start up pre-power on before turning the griddle on verify all electrical connections and remove excess shipping grease from the griddle surface. Turning the power on set the main power switch, located at the far left of the control panel, to the “on” (up) position (there are two “on” swit...
Page 10
0 operation general the suggested time and temperature chart (below) is provided as a guide for the products listed only. If different temperature settings are to be used, select one side of the griddle and operate at the lowest temperature. Adjoining sections should be set at progressively higher t...
Page 11
Warning maintenance & cleaning cleaning • always start with a cold griddle. • the stainless exterior can easily be cleaned using a good non-abrasive cleaner. • always follow the cleaner manufacturer’s instructions when using any cleaner. • always apply these cleaners when the griddle is cold and rub...
Page 12: Symptom
Troubleshooting symptoms what follows is a chart of symptoms and possible causes to aid in diagnosing faults with the griddle. Refer to the symptoms column to locate the type of failure then to the possible cause for the items to be checked. To test for a possible causes refer to the test section an...
Page 13
3 troubleshooting continued notice: serviceonthis,oranyother,langappliancemustbeperformedbyqualified personnel only. Consult your lang authorized service agent directory or call the factory at 1-800-807-9054, or www.Star-mfg.Com for the service agent nearest you. Both high and low voltages are prese...
Page 14
4 yn ap mo c s d c a b c d 1 2 3 4 5 6 7 8 a b c d 1 2 3 4 5 6 7 8 qs ni : o n .G w d f o :v er 20 /5 1/ 01 : n oi tpi rc se d k na lb :. S mi d lai re ta m : # tr ap lai re ta m : ep yt k na lb :a er a :e r a se c n ar el ot 1 1 se l g n a sl a mi ce d d ei fi c ep s e si w r e h t o s s el n u . S...
Page 15
5 9 1 position switch 12 3 2 4 5 4 1 2 3 5 6 8 7 10 2 switch position 12 5 4 3 8 10 9 6 5 7 1 3 4 2 1 position switch 12 3 5 4 1 2 9 10 8 7 4 5 6 2 3 2 30 30 32 32 8 1 2 26 26 3 12 10 1 9 4 3 5 6 28 28 6 3 20 10 1 17 27 27 3 16 10 1 13 9 31 31 lg36 lg24 l1 l2 l3 5 1 griddle elements 2 griddle pilot ...
Page 16
6 sk2319 rev 10/2/2007 136sdi - 160sdi drop-in electric griddle lgd drop-in electric griddle 4 3 1 27 31 30 29 28 33 20 32 21 23 25 24 22 19 5 8 15 14 13 7 6 9 10 11 12 18 17 16 26.
Page 17: Parts List
7 model no: 136sdi, 148sdi, 160sdi selectronic electric drop-in griddle parts list october 3, 2007, rev b important: when ordering, specify voltage or type gas desired page include model and serial number of some items are included for illustrative purposes only and in certain instances may not be a...
Page 18: Parts List
8 model no: 136sdi, 148sdi, 160sdi selectronic electric drop-in griddle parts list october 3, 2007, rev b important: when ordering, specify voltage or type gas desired page include model and serial number of some items are included for illustrative purposes only and in certain instances may not be a...