Lang manufacturing company 6500 merrill creek parkway everett, wa 98203 part number: 60802-02 phone: 425-349-2400 fax: 425-349-2733 © copyright 1998 www.Langworld.Com installation operation maintenance troubleshooting model: 36s lang electric range.
2.
3 introduction this manual contains the necessary information to install, operate, maintain, and service the lang model 36s series electric range. Replacement parts should be genuine lang parts. Failure to use genuine lang replacement parts may result in malfunction of the appliance or possible inju...
4 inspection and installation upon receipt of the range and damage should be noted on the bill of lading and countersigned by the carrier. If concealed damage is discovered the carrier should be notified. All claims must be filed with the carrier. The lang model series 36s electric oven range was de...
5 safety precautions and warnings warning: make sure the six wire leads to supply electricity to the cook top are not crimped between the oven and range top. Warning: make sure the main power supply to the range is turned off at the source prior to connecting power to the range. Refer to inspection ...
6 oven operating instructions range controls three heat switches or automatic thermostats control the top plate units. The range is provided with an upper heating unit located in the op of the oven and a lower heating unit located under the metal deck, in the bottom of the oven. Each heating unit is...
7 range top 12 x 24 hot plate or round speed units, controlled by 3-heat switch, 6-heat switch or high temperature thermostats. Round speed units, controlled by 3-heat switch or 6-heat switch. Recommended: light duty sauce pans and small stockpots. Not recommended: heavy stockpots, or heavy urns, or...
8 normal operation the range oven must be thoroughly preheated before satisfactory baking can be done. The range oven will not bake uniformly if not sufficiently preheated. To compensate for temperature drop when loading the range oven, set the thermostat up 50 ° over the desired temperature. Reset ...
9 caution: any oven cleaner used should be marked: “safe on aluminum”. We recommend “sokoff”. Keep drip pans under range top plates clean. Keep hot plate and griddle surfaces clean. Outside of range and top should be kept clean. Thermostat calibration: all thermostats are factory calibrated and are ...
10 trouble shooting guide symptom problem remedy not heating loose terminal connections tighten terminals improper voltage change voltage to match range defective elements replace elements thermostat inoperative broken capillary tube replace thermostat loose connections tighten terminals improper vo...
11 thermostat replacement: oven inside the oven cavity remove the retaining clips holding the thermostat-sensing bulb in place. Deed the bulb through the oven wall into the control panel area. Remove the wires attached to the thermostat terminals. Remember the terminal each wire was on and attach th...
12 remove the two (2) 10 x 1/2” sheet metal screws holding the capillary tube clamp, if present, to the bottom of the affected element pan. Remove four (4) nuts attaching the wires to the elements. Mark the wires for proper replacement. Remove five (5) 5/16 hex nut holding the element pan to the gri...
13.
14.
15 parts list description part no. Element top plate 208v o/s 2000 watts 11010-09 element top plate 208v i/s 3000 watts 11010-10 element top plate 240v o/s 2000 watts 11010-21 element top plate 240v i/s 3000 watts 11010-22 element top plate 480v o/s 2000 watts 11010-23 element top plate 480v i/s 300...
16 warranty lang manufacturing limited warranty to commercial purchasers* (domestic u.S., hawaii, & canadian sales only.) lang manufacturing equipment (“lang equipment”) has been skillfully manufactured, carefully inspected and packaged to meet rigid standards of excellence. Lang warrants its equipm...
