Lang ECCO-C Quick Programming Manual - Urple
P
URPLE
O
VEN
P
ROGRAMMING
EHS-C, ECCO-C, and GCCO-C
C
ONTROL
P
ANEL
B
UTTON
D
EFINITIONS
1 -0 B
UTTONS
:
Product Buttons. These are the buttons where the product programs are stored.
Pressing a Product Button will heat the oven to the programmed temperature.
A – E B
UTTONS
:
Shelf Buttons. The control is capable of timing each shelf individually. Pressing a
Product Button then a Shelf Button will start the countdown timer.
MAN PROG:
The MANUAL PROGRAM button allows the operator to enter a temporary product
program without being required to input the programming code. The temporary program
is erased when the oven is turned off or when a new program is entered. Time and
temperature are the only parameters that can be entered in the Manual Program mode.
READ/CLEAR:
The READ/CLEAR button has several functions.
¾ It is always the first button pressed when entering programming codes.
¾ Pressing it twice then pressing a Product Button will "read-back the program in that
button.
¾ Pressing and holding the button down until "
88888
" appears in the display will cancel
the current mode of the control and return the display to "
Enter
".
TEMP:
When the Temperature Recall Button is pressed, the display will indicate the internal oven temperature.
When released the display will revert to the previous readout.
S
TATUS
D
ISPLAY
D
EFINITIONS
The Status Display informs the operator of the oven's status. (see Programming Codes)
It can be used as a countdown timer, shelf in use or internal oven temperature display during the cooking cycle.
The Display informs the operator when the oven is ready to bake, or if the oven is above or below the programmed
temperature.
Below is a list of displays and their definitions:
"
ENTER
" The oven is energized and ready for an operator command.
"
PrEht
"
Stands
for
“PREHEAT”. A product has been selected and the oven is heating to the programmed
temperature.
"
rEAdY
” A product has been selected and the oven has preheated to the programmed temperature. The oven is
ready to load a product.
"
COOL
"
The oven's internal temperature is below what is programmed.
"
Hot
"
The oven's internal temperature is above what is programmed.
"
ShELF
" A product selection has been made after the oven has preheated and the computer is asking which shelf
the product is placed on.
"
hELP
"
There is a fault in the control system, the computer will not operate until service is performed.
"
Cont
"
Stands for “CONTINUOUS”. The oven has been programmed without a time being entered. The
oven will operate continuously at the programmed temperature.
"
ErrOr
" An entry has been made during the programming, which the computer does not understand.
Page 2 of 4
Purple Programming.doc